Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Fabberge
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 134
Search took 0.03 seconds.
Search: Posts Made By: KTMracing09
Forum: General Automotive + Other Cars Discussion 07-15-2014, 12:09 AM
Replies: 95
Views: 4,236
Posted By KTMracing09
What is chevy going to do

The hellcat at 707hp and now this...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-06-2014, 01:53 PM
Replies: 12
Views: 743
Posted By KTMracing09
:sm0:

:sm0:
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-06-2014, 01:50 PM
Replies: 12
Views: 743
Posted By KTMracing09
Why?

Why are mustangs so much louder than camaros? I have long tubes and full 3 inch exhaust with off road pipes, so my car isn't quiet by no means, but I feel like I always see mustangs that are louder...
Forum: Cosmetics and Lighting Modification Discussions 06-19-2014, 02:47 PM
Replies: 0
Views: 84
Posted By KTMracing09
Question Who has....

Who has a street scene splitter with zl1 side rockers? Does the street Scene splitter flow well with zl1 rockers? I'm thinking about doing this set up, I know the slp splitter flows pretty well with...
Forum: Chevy Camaro vs... 06-19-2014, 01:53 AM
Replies: 21
Views: 1,353
Posted By KTMracing09
Get a set of long tubes as stated before. You'll...

Get a set of long tubes as stated before. You'll love them! Then once you win take that $500 and consider it a set of long tubes for practicality $200, considering most run around $700
Forum: 5th Gen Camaro SS LS LT General Discussions 06-18-2014, 08:13 PM
Replies: 13
Views: 833
Posted By KTMracing09
Since you don't know if it is tuned or not I...

Since you don't know if it is tuned or not I would say try a fuse pull, couldn't hurt to try
Forum: 5th Gen Camaro SS LS LT General Discussions 06-18-2014, 05:19 PM
Replies: 13
Views: 833
Posted By KTMracing09
I have an auto and if I put my car in 1st, roll...

I have an auto and if I put my car in 1st, roll at about 15 mph and then floor it I'll spin through the rest of 1st gear and chirp 2nd gear with traction control ON. So I would assume a m6 could. As...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-17-2014, 10:25 PM
Replies: 10
Views: 573
Posted By KTMracing09
Your goal is definitely achievable with stock...

Your goal is definitely achievable with stock trans and rear end as I've seen 600+rwhp L99's. I do not know the absolute max power rating though, but if 500 is all you want then you're good
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-17-2014, 10:02 PM
Replies: 2,138
Views: 123,823
Posted By KTMracing09
once, and that was cause my battery was dead

once, and that was cause my battery was dead
Forum: Cosmetics and Lighting Modification Discussions 06-17-2014, 09:47 PM
Replies: 11
Views: 824
Posted By KTMracing09
Theres a DIY write up in the DIY section. As I...

Theres a DIY write up in the DIY section. As I said before, just go to your local hardware store and get you two 4 foot pieces of 3/4 hose. Probably cheaper than GM hoses for the 2012+ models
Forum: Cosmetics and Lighting Modification Discussions 06-17-2014, 04:27 PM
Replies: 11
Views: 824
Posted By KTMracing09
I most definitely will!

I most definitely will!
Forum: Cosmetics and Lighting Modification Discussions 06-17-2014, 04:22 PM
Replies: 11
Views: 824
Posted By KTMracing09
:thanks:

:thanks:
Forum: Cosmetics and Lighting Modification Discussions 06-17-2014, 04:20 PM
Replies: 11
Views: 824
Posted By KTMracing09
Went to the hardware store and bought two 4 foot...

Went to the hardware store and bought two 4 foot pieces of 3/4" hose, cost me $16, works great, no leaks, not worth spending the money on a kit.
Forum: Cosmetics and Lighting Modification Discussions 06-17-2014, 12:55 PM
Replies: 11
Views: 824
Posted By KTMracing09
Engine bay clean up

Did the coolant hose relocation and tidied up a bit. If you're running no engine cover the hose relocation is a must! Looks so much better
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-15-2014, 08:29 AM
Replies: 16
Views: 1,095
Posted By KTMracing09
Night fury vvt

I fell in love with the sound and performance of this cam but wanted to keep vvt, and since it has came out in vvt has anybody installed it? Curious about the driveability
Forum: Dragstrip and Launch Techniques Discussion 06-14-2014, 04:56 PM
Replies: 14
Views: 972
Posted By KTMracing09
Yes it's a 1.88, my best and only 60' in the 1's....

Yes it's a 1.88, my best and only 60' in the 1's. Normally I pull 2.0-2.2 60's. I don't know what I did differently to achieve that 1.88 though, I did everything like I normally do :noidea:
Forum: 5th Gen Camaro SS LS LT General Discussions 06-13-2014, 01:52 AM
Replies: 54
Views: 4,061
Posted By KTMracing09
+1 :headbang:

+1 :headbang:
Forum: Tuning / Diagnostics -- engine and transmission 06-10-2014, 09:40 PM
Replies: 1
Views: 272
Posted By KTMracing09
Quick question?

I used my sct to raise my idle 100 Rpm in both drive idle and park idle. I pulled into my driveway and sat with my foot on the break for about 5 seconds sitting still, go to put it in park and it...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-09-2014, 06:32 PM
Replies: 53
Views: 3,083
Posted By KTMracing09
Yea after a little break in if I'm not satisfied...

Yea after a little break in if I'm not satisfied I'll probably take the mufflers out. I saw you say you didn't have much clearance with the steering shaft, I didn't have any clearance issue, it's...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-08-2014, 06:51 AM
Replies: 53
Views: 3,083
Posted By KTMracing09
I just finished the install yesterday; the...

I just finished the install yesterday; the headers and full exhaust with off-road extensions. And I was kinda disappointed with the sound level, it screams at WOT exactly how I would want it, but at...
Forum: Dragstrip and Launch Techniques Discussion 05-29-2014, 01:47 AM
Replies: 14
Views: 972
Posted By KTMracing09
Yeah I live about 15 minutes from the track

Yeah I live about 15 minutes from the track
Forum: Dragstrip and Launch Techniques Discussion 05-29-2014, 01:47 AM
Replies: 14
Views: 972
Posted By KTMracing09
It definitely does!

It definitely does!
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-28-2014, 07:52 PM
Replies: 53
Views: 3,083
Posted By KTMracing09
About to do my install too. Tried to watch your...

About to do my install too. Tried to watch your video and it won't work
Forum: Dragstrip and Launch Techniques Discussion 05-24-2014, 12:09 AM
Replies: 14
Views: 972
Posted By KTMracing09
New personal best

Pretty excited, not in the teens no more!
Forum: Camaro Photos | Spyshots | Video | Media Gallery 05-18-2014, 11:04 AM
Replies: 65
Views: 4,050
Posted By KTMracing09
Nice pics bud! I did the same thing :thumbsup:

Nice pics bud! I did the same thing :thumbsup:
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-18-2014, 10:34 AM
Replies: 53
Views: 3,083
Posted By KTMracing09
I'll be sure to post one as I am anxious as I am...

I'll be sure to post one as I am anxious as I am sure others are to hear how it sounds for the price it costs. Should be done sometime next week
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-18-2014, 08:20 AM
Replies: 53
Views: 3,083
Posted By KTMracing09
The gaskets that come with look okay, but I'm...

The gaskets that come with look okay, but I'm going to use oem gaskets
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-14-2014, 08:55 PM
Replies: 53
Views: 3,083
Posted By KTMracing09
:cool:

:cool:
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-14-2014, 08:46 PM
Replies: 53
Views: 3,083
Posted By KTMracing09
I ordered their headers and they just arrived...

I ordered their headers and they just arrived today. They are constructed pretty nicely and the welds look good. They're 2" inlet, 3" outlet. Its a great purchase for price. Won't have them installed...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-07-2014, 07:10 PM
Replies: 16
Views: 887
Posted By KTMracing09
Once I put on the Long tubes and catback I wont...

Once I put on the Long tubes and catback I wont be putting the cutouts back on, that why I wanted to know if that set up will be louder than stock with cutouts.
Showing results 1 to 30 of 134

 
Forum Jump

All times are GMT -5. The time now is 06:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.