Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
dave@hennessey
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.04 seconds. Search: Posts Made By: MightymouseSS
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-14-2017, 11:29 AM
Replies: 7
Views: 2,572
Posted By MightymouseSS
Bent valves? I had issues with oil burning and...

Bent valves? I had issues with oil burning and smoke re-did seals x5. End up being a bad grind from comp and had cam walk. Replaced cam with camotion core and haven't burnt a drop of oil since. My...
Forum: Suspension / Chassis / Brakes 05-27-2017, 12:48 AM
Replies: 7
Views: 2,710
Posted By MightymouseSS
How much for rear sway bar?

How much for rear sway bar?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-23-2017, 07:17 AM
Replies: 4
Views: 827
Posted By MightymouseSS
You can also do #5 and #20 fuse pull.

You can also do #5 and #20 fuse pull.
Forum: Transmission / Driveline 07-15-2016, 10:56 AM
Replies: 9
Views: 1,545
Posted By MightymouseSS
Needed those 2 weeks ago. They are on national...

Needed those 2 weeks ago. They are on national back order from GM.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 11-04-2015, 05:05 PM
Replies: 16
Views: 4,790
Posted By MightymouseSS
I recently replaced the stock H pipe for a X pipe...

I recently replaced the stock H pipe for a X pipe with resonator delete and it changes the exhaust tone mostly but not making it any louder drone is about the same with my LM2 mufflers. It has a deep...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 11-03-2015, 02:11 AM
Replies: 22
Views: 4,922
Posted By MightymouseSS
I have the same issue i purchased falken tires...

I have the same issue i purchased falken tires for the front of my SS and i can feel a slight vibration that wasn't there before. Ive had the car alighned and tires balanced twice and the vibration...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-25-2015, 12:12 AM
Replies: 51
Views: 9,596
Posted By MightymouseSS
My limiter is set to 6800. I usually shift at...

My limiter is set to 6800. I usually shift at 6500/6600ish. Power starts tapering off on my dyno at about 6500ish no need to rev the piss out of it more.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 10-13-2015, 06:59 PM
Replies: 11
Views: 2,123
Posted By MightymouseSS
You can get a new system for $624...

You can get a new system for $624 @marylandspeed.com
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-10-2015, 04:18 PM
Replies: 15
Views: 4,786
Posted By MightymouseSS
Just slap in 7.425s and call it a day.

Just slap in 7.425s and call it a day.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-09-2015, 09:25 PM
Replies: 2
Views: 1,069
Posted By MightymouseSS
Not much of a difference. I recently deleted mine...

Not much of a difference. I recently deleted mine and added a x pipe and the pitch has changed a lil bit but no increase in volume. I did notice a lil bit less drone.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-29-2015, 02:02 PM
Replies: 30
Views: 4,722
Posted By MightymouseSS
Whatc was your baseline before the cam?

Whatc was your baseline before the cam?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-29-2015, 02:00 PM
Replies: 22
Views: 2,949
Posted By MightymouseSS
Stockers here as well. Shop where i had the cam...

Stockers here as well. Shop where i had the cam installed said that it good but not a absolute must do. He recommended if the car was gonna see a lot of track use or constant high rpm then it would...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-17-2015, 10:28 AM
Replies: 9
Views: 2,569
Posted By MightymouseSS
LM2 here. They sound good actually pretty tame....

LM2 here. They sound good actually pretty tame. Drone is present but i heard worse.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-17-2015, 10:23 AM
Replies: 6
Views: 1,594
Posted By MightymouseSS
I recently did a xpipe and eleminated the Hpipe...

I recently did a xpipe and eleminated the Hpipe and resonators. Power wise the throttle respone feels just a hair more responsive but nothing significant and sound is a lil higher pitched and the cam...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-13-2015, 10:28 PM
Replies: 24
Views: 4,507
Posted By MightymouseSS
Josh spartan lsx mine broke a spring and i never...

Josh spartan lsx mine broke a spring and i never got a CEL or noise i discovered it by physically taking off the valve cover. Otherwise i would've never known.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-10-2015, 12:15 AM
Replies: 30
Views: 4,722
Posted By MightymouseSS
I have about 10k on my cam only issues have been...

I have about 10k on my cam only issues have been leaking valve seals due to having the wrong sized locators (packaging mistake). But other than that nothing more and i have a comp core. Some ppl...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-10-2015, 12:10 AM
Replies: 5
Views: 1,076
Posted By MightymouseSS
7.425 on mine but lethal says 7.40 is fine as...

7.425 on mine but lethal says 7.40 is fine as well both will work fine.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-07-2015, 03:21 PM
Replies: 30
Views: 4,722
Posted By MightymouseSS
I wenf with 7.425 push rods and BTR .660 spring...

I wenf with 7.425 push rods and BTR .660 spring with Ti retainers.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-05-2015, 12:29 AM
Replies: 26
Views: 5,880
Posted By MightymouseSS
Mine dips at 4900ish too. Till i cammed it i lost...

Mine dips at 4900ish too. Till i cammed it i lost a lil on the low end but the tq stays over 400ft lbs tq at 3500 all the way to about 6000.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-04-2015, 06:59 PM
Replies: 8
Views: 1,691
Posted By MightymouseSS
Ive seen a few here. Good luck man you'll love...

Ive seen a few here. Good luck man you'll love that cam.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-04-2015, 06:47 PM
Replies: 8
Views: 1,691
Posted By MightymouseSS
Just get a new one man its one of those parts...

Just get a new one man its one of those parts you'd rather have new.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-04-2015, 12:19 PM
Replies: 26
Views: 5,699
Posted By MightymouseSS
If your losing oil you probably have bad valve...

If your losing oil you probably have bad valve seals.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-03-2015, 09:44 PM
Replies: 4
Views: 4,119
Posted By MightymouseSS
Not reverse but 1st to 2nd gear yes.

Not reverse but 1st to 2nd gear yes.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-01-2015, 05:17 PM
Replies: 3
Views: 1,821
Posted By MightymouseSS
Mcleod RST?

I recently replaced my stock clutch out cause my slave cylinder gave out. I replaced it with a mcleod rst and gm slave with monster bearing support. Since the i feel the pedal to soft or spongy and...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 07-28-2015, 12:57 AM
Replies: 3
Views: 1,078
Posted By MightymouseSS
Too expensive seen those go for $200 to 225...

Too expensive seen those go for $200 to 225 shipped.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-24-2015, 08:43 AM
Replies: 24
Views: 4,507
Posted By MightymouseSS
I broke a BTR .660 not to long ago. It never made...

I broke a BTR .660 not to long ago. It never made any weird noises or gave me idling issues only reason i found out was cuz i removed the valve covers to inspect the valve seals cuz my car was...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-24-2015, 07:07 AM
Replies: 20
Views: 4,656
Posted By MightymouseSS
I haven't been on a mustang dyno yet. I dyoned...

I haven't been on a mustang dyno yet. I dyoned last year on a heartbreaker awd dyno jet and still mustered up 455 to the wheels in 101° july heat. Ill take a crack on a mustang today if not sometime...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-22-2015, 05:48 AM
Replies: 14
Views: 4,004
Posted By MightymouseSS
I've tried different things to get rid of this...

I've tried different things to get rid of this issue. I have amsoil aft in the tranny which helped smoother shifts but doesn't cure the grind. I also have a separate reservoir and that helped a lil...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-12-2015, 10:48 PM
Replies: 42
Views: 4,902
Posted By MightymouseSS
I have a NF cam from lethal. I have btr .660...

I have a NF cam from lethal. I have btr .660 springs with Ti retainers, btr 7.425 push rods, melling hv oil pump, ls2 tensioner, and stock rockers, chain and trunions for now.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-12-2015, 10:39 PM
Replies: 27
Views: 6,937
Posted By MightymouseSS
Bottom is ls3.

Bottom is ls3.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 11:16 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.