Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
HeadlightArmor
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 36
Search took 0.01 seconds.
Search: Posts Made By: SSKyle
Forum: Forced Induction - V8 06-05-2014, 08:36 PM
Replies: 7
Views: 362
Posted By SSKyle
There is no need to remove the alt to install the...

There is no need to remove the alt to install the new plug and fitting. If I remember right, I removed the bottom 2 bolts and swiveled it out of the way when I installed mine.
Forum: Forced Induction - V8 05-10-2014, 09:15 PM
Replies: 0
Views: 233
Posted By SSKyle
AIS meth kit

Those of you with the AIS kit, what wire did you use for the 12v ignition power source?
Forum: Forced Induction - V8 03-08-2014, 06:35 PM
Replies: 28
Views: 1,776
Posted By SSKyle
X2 If this is a direct replacement, would...

X2

If this is a direct replacement, would the 3" down pipe in the old tuner kit flow enough to keep back pressure down at higher boost levels?
Forum: Forced Induction - V8 06-04-2013, 03:08 PM
Replies: 5
Views: 422
Posted By SSKyle
Above would be better, but as long as the fitting...

Above would be better, but as long as the fitting is out of oil so that there is no restriction on the returning oil you should be ok.
Drilling the hole exactly 3in from bottom of oil pan like it...
Forum: Forced Induction - V8 03-24-2013, 05:58 PM
Replies: 8
Views: 493
Posted By SSKyle
Thanks a lot. How hard was it to get to the...

Thanks a lot.
How hard was it to get to the fpcm? I know you have to remove the back seat and the side panel, but other than that is it pretty a straight forward install?
Forum: Forced Induction - V8 03-24-2013, 03:39 PM
Replies: 8
Views: 493
Posted By SSKyle
ADM FPCM

Can anyone post up a link for the fpcm for the ZL1 pump? I can't find it on their site.
Thanks
Forum: Forced Induction - V8 02-20-2013, 11:06 AM
Replies: 9
Views: 404
Posted By SSKyle
The fuel has been in the tank for a few months...

The fuel has been in the tank for a few months now due to repairs and bad weather. Before the car was parked I was getting some KR and tuner said has to be bad fuel and to take it easy until I burn...
Forum: Forced Induction - V8 02-19-2013, 10:14 PM
Replies: 9
Views: 404
Posted By SSKyle
Draining fuel tank?

My car has a half of a tank of fuel in it an was wondering if there was an easy way to drain the bad fuel out WITHOUT removing the tank? I seen an old post where a member used up tuners to run fuel...
Forum: Forced Induction - V8 02-08-2013, 04:24 PM
Replies: 48
Views: 2,947
Posted By SSKyle
Stock ls3 Zl1pump I'd 850 Zr1 map Zr1...

Stock ls3
Zl1pump
I'd 850
Zr1 map
Zr1 plugs
7 psi
Forum: Forced Induction - V8 02-08-2013, 04:17 PM
Replies: 48
Views: 2,947
Posted By SSKyle
+1. My car does the exact same, but doesn't...

+1. My car does the exact same, but doesn't crank as long( maybe 1-4 cranks more than normal). I have the turbonetics kit with no cam.
Forum: Forced Induction - V8 11-03-2012, 10:20 PM
Replies: 122
Views: 7,573
Posted By SSKyle
Nice numbers! You going to the shootout tomorrow?

Nice numbers! You going to the shootout tomorrow?
Forum: Forced Induction - V8 07-24-2012, 09:41 PM
Replies: 19
Views: 999
Posted By SSKyle
It wasn't too bad where I tapped mine. I had to...

It wasn't too bad where I tapped mine. I had to take the sway bar loose an the hot wire to starter. It put the fitting just above baffle. Haven't had any problems since.
Forum: Forced Induction - V8 07-24-2012, 09:06 PM
Replies: 19
Views: 999
Posted By SSKyle
Yea unfortunatley. I have been in a mess. I...

Yea unfortunatley. I have been in a mess. I drilled the hole to where the bottom of the 9/16 hole was a fuzz above 3" (like a 1/16") and the fitting was still under oil. If i went any higher I...
Forum: Forced Induction - V8 07-24-2012, 08:43 PM
Replies: 19
Views: 999
Posted By SSKyle
In the instructions they show the fitting on the...

In the instructions they show the fitting on the drivers side corner of the pan (just to the right of your hand). I actually left all the oil in my pan when I drilled my pan, kinda makes a mess but...
Forum: Forced Induction - V8 06-26-2012, 08:31 PM
Replies: 10
Views: 727
Posted By SSKyle
What size of restrictors did he use?

What size of restrictors did he use?
Forum: Forced Induction - V8 06-26-2012, 02:28 PM
Replies: 10
Views: 727
Posted By SSKyle
I have about come to this, a 1/8in hole with...

I have about come to this, a 1/8in hole with 50+psi oil pressure is alot of oil inside that little area. I have several buddies with 106mm turbos running alot smaller oil feed orifices without...
Forum: Forced Induction - V8 06-26-2012, 01:47 PM
Replies: 10
Views: 727
Posted By SSKyle
It says on their site that this turbo has the...

It says on their site that this turbo has the ceramic ball bearings??

So I just finished pulling the charge pipe off the car and there is oil in the charge pipe.. There was barely a trace on the...
Forum: Forced Induction - V8 06-25-2012, 09:04 PM
Replies: 10
Views: 727
Posted By SSKyle
Turbo oil trouble???

I have the turbonetics T76 kit with -8an return line and a -3an oil feed line. The car is leaving a light blue haze when it gets into boost (6psi) but does not smoke at idle.
Turbonetics does not...
Forum: Forced Induction - V8 06-05-2012, 08:53 PM
Replies: 6
Views: 891
Posted By SSKyle
Ok, thanks alot guys. I just finshed putting the...

Ok, thanks alot guys. I just finshed putting the pump in this morning and wanted to make sure before I had the car off the stands.

Also for those of you with turbo's with a wideban A/F gauge, ...
Forum: Forced Induction - V8 06-05-2012, 02:43 PM
Replies: 6
Views: 891
Posted By SSKyle
Fuel Pressure Regulator

So I just installed the Turbonetics kit on my car and I'm just finishing everything up to get it tuned. I installed the ZL1 pump with FAST 65 injectors. Will I need to get a boost referenced...
Forum: Forced Induction - V8 04-13-2012, 06:10 PM
Replies: 14
Views: 708
Posted By SSKyle
Is your car stock other than the Turbonetics kit?

Is your car stock other than the Turbonetics kit?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-20-2012, 07:47 PM
Replies: 1
Views: 663
Posted By SSKyle
Best place to purchase Mcleod RXT clutch?

I will be purchasing a new clutch within the next few days and have my mind set on the Mcleod RXT and was just wondering where's the cheapest/best place to purchase?

Also with those of you who...
Forum: Forced Induction - V8 02-23-2012, 11:39 AM
Replies: 84
Views: 14,009
Posted By SSKyle
I bought a tuner kit an I knew the complete kit...

I bought a tuner kit an I knew the complete kit came with 63lb/hr I believe so I went with 65's. I hoping that I will be ok with a bap and those injectors... I plan on running no more than 9 psi.
Forum: Forced Induction - V8 02-22-2012, 04:53 PM
Replies: 84
Views: 14,009
Posted By SSKyle
I'm getting ready to install this same kit an was...

I'm getting ready to install this same kit an was wondering what my factory pump would handle with FAST 65lb/hr injectors. What was the duty cycle of the injectors at 8psi?
Forum: Forced Induction - V8 02-22-2012, 04:38 PM
Replies: 84
Views: 14,009
Posted By SSKyle
What kind of fuel upgrades do you have done? Only...

What kind of fuel upgrades do you have done? Only injectors?
Forum: Forced Induction - V8 02-19-2012, 08:47 PM
Replies: 9
Views: 806
Posted By SSKyle
Has anyone had any trouble when they tapped into...

Has anyone had any trouble when they tapped into their oil pan? I plan on doing the install myself and was wondering about this.
Forum: Forced Induction 01-04-2012, 06:04 PM
Replies: 13
Views: 1,405
Posted By SSKyle
Still for sale?

Still for sale?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-02-2011, 05:09 PM
Replies: 5
Views: 448
Posted By SSKyle
Max duration/lift before PTV issues?

How much duration and lift is tolerable before having PTV problems?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-29-2011, 11:25 AM
Replies: 5
Views: 469
Posted By SSKyle
Factory oil pumps?

I went to a local performance shop a few days ago to order parts for a cam swap. When I told him I wanted a melling oil pump, he ask why and I told him about the problems with the factory pumps. He...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-27-2011, 09:52 AM
Replies: 28
Views: 1,908
Posted By SSKyle
What short throw shifter should I go with?

Which shifter is everyone running/ had the best luck with? Looking into getting one shortly and would like some input.. Post some pics also to give me an idea..
Thanks in advance
Showing results 1 to 30 of 36

 
Forum Jump

All times are GMT -5. The time now is 04:44 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.