Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 249
Search took 0.03 seconds.
Search: Posts Made By: Rock on
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 08:27 PM
Replies: 14
Views: 6,002
Posted By Rock on
How did you secure your E Brake cable

How did you secure your E Brake cable
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:33 PM
Replies: 14
Views: 6,002
Posted By Rock on
Test and tune this sat

Test and tune this sat
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:31 PM
Replies: 14
Views: 6,002
Posted By Rock on
The front wheels are easy just cut off the roller...

The front wheels are easy just cut off the roller skates. My calipers need paint anyway so I just cut them installed with a sawza
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:26 PM
Replies: 14
Views: 6,002
Posted By Rock on
Don’t even bother with stick on weights to...

Don’t even bother with stick on weights to balance the rear tires there is almost zero space between the wheel and the lower control arm . It will spin in the air but on the ground it won’t clear
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:21 PM
Replies: 14
Views: 6,002
Posted By Rock on
You will also need to tie back you E brake line I...

You will also need to tie back you E brake line I still am not satisfied with mine yet (zip tie) also where the crush washer is on the caliper the brake line needs to be turned inward
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:16 PM
Replies: 14
Views: 6,002
Posted By Rock on
On the passenger side you will need to use a...

On the passenger side you will need to use a flush mount screw and bend the tab in that holds your fuel tube
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:12 PM
Replies: 14
Views: 6,002
Posted By Rock on
Then you will need to grind off part of the brake...

Then you will need to grind off part of the brake line brakes on the inner fender well and relocate the brake line . I used a hose clamp from ace hardware
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:08 PM
Replies: 14
Views: 6,002
Posted By Rock on
In order to get these tire to fit you need to...

In order to get these tire to fit you need to trim your inner fender liner, this is easy trace your tire with your car off the ground , deeply scratch with a razor knife and they will snap off where...
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 04:02 PM
Replies: 14
Views: 6,002
Posted By Rock on
The front tires are M&H 28x4.5 radials rear are...

The front tires are M&H 28x4.5 radials rear are Micket Thompson ET Street 325/50 R15
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 03:54 PM
Replies: 14
Views: 6,002
Posted By Rock on
For the wheels I went with Weld 15x10 7.5...

For the wheels I went with Weld 15x10 7.5 backspace tear weld 17x5 front
Forum: Camaro DIY & HOW-TO instructions & discussions 04-12-2018, 03:49 PM
Replies: 14
Views: 6,002
Posted By Rock on
15” conversion and 325 50 15 fitment

I haven’t been on here for awhile but I thought this would be beneficial to anyone considering this mod. It all started last year when my wife bought me an lsa supercharger, my car was already...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 01-24-2018, 10:10 AM
Replies: 2
Views: 742
Posted By Rock on
What 15” wheel ?

I just installed Carlyle Racing’s 15” brake conversion with BMR’s drag control arm package. It seems like most go people go with Weld 15” rear 17” front. I just want to see what other options are out...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 06-21-2016, 09:27 PM
Replies: 31
Views: 3,984
Posted By Rock on
About 2 min left foot on the break right foot on...

About 2 min left foot on the break right foot on the gas push hard
Forum: 5th Gen Camaro SS LS LT General Discussions 06-21-2016, 09:22 PM
Replies: 14
Views: 3,377
Posted By Rock on
I had solos before I went long tubes they will...

I had solos before I went long tubes they will give you about 20rwhp I haven't had mufflers since the car was new ,loud is what I like , you will need to tune out the fuel management or you will hate...
Forum: 5th Gen Camaro SS LS LT General Discussions 11-22-2014, 07:48 PM
Replies: 91
Views: 15,931
Posted By Rock on
These cars have Cruise Control ?

These cars have Cruise Control ?
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 06-15-2014, 08:30 AM
Replies: 9
Views: 2,680
Posted By Rock on
Clay bar after bug and tar remover and good wash...

Clay bar after bug and tar remover and good wash then wax
Forum: 1st & 2nd Generation Camaros 05-14-2014, 06:22 PM
Replies: 11
Views: 13,223
Posted By Rock on
Agree

Agree
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-13-2014, 06:39 AM
Replies: 29
Views: 13,407
Posted By Rock on
That pic alone is a good reason for muffler delete

That pic alone is a good reason for muffler delete
Forum: 5th Gen Camaro SS LS LT General Discussions 05-12-2014, 09:44 PM
Replies: 85
Views: 10,556
Posted By Rock on
Turn them off you never know when you will need...

Turn them off you never know when you will need to do a burnout
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-12-2014, 07:39 AM
Replies: 56
Views: 16,243
Posted By Rock on
I have a Yank 3600 it flashes right on, car likes...

I have a Yank 3600 it flashes right on, car likes to cruise at around 2200 only complaint and this is prob large cam stall combo is freeway 60 -65 I need to downshift to 5th to keep rpms up to where...
Forum: Canada 05-11-2014, 08:49 PM
Replies: 15
Views: 5,972
Posted By Rock on
That's nice well done

That's nice well done
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 05-11-2014, 08:38 PM
Replies: 13
Views: 2,357
Posted By Rock on
I only cover my 68 firebird it rarely gets drove,...

I only cover my 68 firebird it rarely gets drove, and I always get help covering it, sits inside only. I would be afraid to keep it covered outside to much wind and dust might act like sandpaper
Forum: New Member Introductions 05-11-2014, 08:20 PM
Replies: 20
Views: 3,158
Posted By Rock on
Welcome ,looks nice

Welcome ,looks nice
Forum: Off-topic Discussions 05-11-2014, 08:03 PM
Replies: 66
Views: 10,427
Posted By Rock on
People who don't use their signals to turn when...

People who don't use their signals to turn when your sitting at a stop sign and they can see your waiting for them to pass
Forum: Camaro Convertible Forum 05-11-2014, 07:59 PM
Replies: 56
Views: 8,129
Posted By Rock on
Sorry for your loss . It looks like he enjoyed...

Sorry for your loss . It looks like he enjoyed life
Forum: Camaro Motorsports Discussions 05-09-2014, 07:42 PM
Replies: 25
Views: 5,451
Posted By Rock on
Thank's I'll do that

Thank's I'll do that
Forum: Camaro Motorsports Discussions 05-09-2014, 07:34 PM
Replies: 25
Views: 5,451
Posted By Rock on
Where do you guys get your helmets

Went to the track the for the first time and the inspector did not like my beat up MX helmet . He let me race but suggested I get a new one for next time. I have no idea who sells auto helmets
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-08-2014, 10:16 PM
Replies: 29
Views: 13,407
Posted By Rock on
The shop I went to just made a new pipe and...

The shop I went to just made a new pipe and reused my stock tips
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-08-2014, 10:10 PM
Replies: 29
Views: 13,407
Posted By Rock on
That what I did

That what I did
Forum: Cosmetics and Lighting Modification Discussions 05-08-2014, 10:04 PM
Replies: 28
Views: 5,140
Posted By Rock on
MPD rocks

MPD rocks
Showing results 1 to 30 of 249

 
Forum Jump

All times are GMT -5. The time now is 10:34 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.