Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Apex Paul
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums


Showing results 1 to 30 of 483
Search took 0.06 seconds.
Search: Posts Made By: Missile Man
Forum: Forced Induction - V8 08-06-2015, 08:41 AM
Replies: 608
Views: 49,508
Posted By Missile Man
Living in AZ I purchased a phenolic spacer that...

Living in AZ I purchased a phenolic spacer that insulates the blower from the motor. The temperature is over 100 degrees and my radiator temp stays consistent at 194 degrees at idle and driving. No...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-05-2015, 09:00 AM
Replies: 18
Views: 600
Posted By Missile Man
I had 36" custom J pipes installed for drone at...

I had 36" custom J pipes installed for drone at around 1.2K RPMS. What little drone that was left did occur at a slightly higher RPM. My J pipes aren’t adjustable but the drone is no longer an issue...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 07-23-2015, 08:19 AM
Replies: 2
Views: 164
Posted By Missile Man
Tire Wear

My rear wheels are wearing in the middle of the thread on my 2010 2SS. The tires are at the right pressure and the outer portion of the thread on either side is good.

I'll have to get my tire...
Forum: Forced Induction - V8 07-18-2015, 10:12 AM
Replies: 14
Views: 729
Posted By Missile Man
Here it cost ~ $13.00 weather you pass or fail....

Here it cost ~ $13.00 weather you pass or fail. Pretty cheap.
Forum: Forced Induction - V8 07-17-2015, 08:50 AM
Replies: 14
Views: 729
Posted By Missile Man
I lived in CA for many years and there smog...

I lived in CA for many years and there smog certification process is more involved. They did check under the hood and measure exhaust gases. If you pass the exhaust portion on the test I don't see...
Forum: Forced Induction - V8 07-15-2015, 10:51 AM
Replies: 14
Views: 729
Posted By Missile Man
Did thay analyze the exhaust gases?

Did thay analyze the exhaust gases?
Forum: Forced Induction - V8 07-14-2015, 08:42 AM
Replies: 14
Views: 729
Posted By Missile Man
No, had it done at a state run facility.

No, had it done at a state run facility.
Forum: Forced Induction - V8 07-14-2015, 08:40 AM
Replies: 14
Views: 729
Posted By Missile Man
Yes, they checked for codes.

Yes, they checked for codes.
Forum: Forced Induction - V8 07-14-2015, 08:14 AM
Replies: 14
Views: 729
Posted By Missile Man
I've Been Smogged

I received my car registration this month and found I needed to get a smog certificate. I was concerned due to my mods I have. I'm not sure if I lucked out but the smog cert place I went to never...
Forum: 4th Generation Camaros 06-11-2015, 01:07 PM
Replies: 11
Views: 691
Posted By Missile Man
The price seems high for the milage the car has....

The price seems high for the milage the car has. Have you checked NADA or Kelly Blue Book?
Forum: 4th Generation Camaros 06-11-2015, 11:45 AM
Replies: 1
Views: 347
Posted By Missile Man
Orifice Tube Help

Hello,

I'm replacing the AC compressor on my wifes 2002 V6 Camaro. Where is the orifice tube located? Anyone have a pic? Can't find any info on the web.
Forum: Forced Induction - V8 04-05-2015, 12:27 PM
Replies: 0
Views: 122
Posted By Missile Man
P0113E and P0114A

I've installed my SC around 9/14 with no issues. Today I received DTC errors P0113E and P0114A. My inter-cooler reservoir did start to leak but I've been filling it until the new one comes. The...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-01-2015, 10:43 AM
Replies: 4
Views: 231
Posted By Missile Man
Thanks for the info.

Thanks for the info.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-01-2015, 09:01 AM
Replies: 4
Views: 231
Posted By Missile Man
O2 Sensor Errors

I received no replys in the Gen4 forum so,
My wife's 2002 V6 Camaro is getting o2 sensor errors in the DTC. One is bank 1 sensor 0 and the other is bank 1 sensor 1. Which side is bank 1 on, driver...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 03-01-2015, 08:47 AM
Replies: 2
Views: 493
Posted By Missile Man
If your Camaro is idling rough or stalling you...

If your Camaro is idling rough or stalling you should definitely clean the filter. It depends on where you drive and how much you drive. I'm in AZ where it's dusty and clean mine every other oil...
Forum: 4th Generation Camaros 02-22-2015, 02:11 PM
Replies: 0
Views: 439
Posted By Missile Man
O2 Sensor Errors

My wife's 2002 Camaro is getting o2 sensor errors in the DTC. One is bank 1 sensor 0 and the other is bank 1 sensor 1. Which side is bank 1 on, driver or passenger? I'm not sure if I can even get to...
Forum: Forced Induction - V8 02-22-2015, 06:37 AM
Replies: 11
Views: 730
Posted By Missile Man
I've been running stock lifters for about a year,...

I've been running stock lifters for about a year, no issues so far. Have VVT/AFM tuned out. Down the road I plan on upgrading the valve train, lifter, push rods, VVT delete ect. Since she's running...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-20-2015, 02:58 PM
Replies: 8
Views: 492
Posted By Missile Man
Took some pic's, not the greatest but I think...

Took some pic's, not the greatest but I think they show how it's routed.

1. Runs from front end of muffler between muffler and fender well.
2. The end is bent upward into the fender well.

Hope...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-20-2015, 06:11 AM
Replies: 8
Views: 492
Posted By Missile Man
I'll take some today.

I'll take some today.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-19-2015, 02:44 PM
Replies: 8
Views: 492
Posted By Missile Man
I had the j-pipes placed between the mufflers and...

I had the j-pipes placed between the mufflers and up inside the quarter panels, there's allot of room there. Good luck.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-19-2015, 02:02 PM
Replies: 8
Views: 492
Posted By Missile Man
I just had 36 inch j-pipes install and I'm happy...

I just had 36 inch j-pipes install and I'm happy to say the drone is all but gone, no more vibration. I also noticed that acceleration is better through the lower RPM's. The 36 inch pipes fit with no...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-19-2015, 08:00 AM
Replies: 8
Views: 492
Posted By Missile Man
J-Pipe Today

It's been a while since I upgraded my exhaust and I still do not like the drone at low RPM's. The drone starts around 1.2k RPM's. The pipe length chart starts at 1.4K RPM with 36 inch j-pipes.

...
Forum: Forced Induction - V8 10-18-2014, 04:11 PM
Replies: 214
Views: 16,107
Posted By Missile Man
Thanks!

Thanks!
Forum: Forced Induction - V8 10-18-2014, 01:33 PM
Replies: 4
Views: 564
Posted By Missile Man
Need assistance on installing my Apex catch can...

Need assistance on installing my Apex catch can with the maggie. I'm in the middle installing and am not sure how to proceed with the connections.

The catch can instructions are for a non-FI...
Forum: Forced Induction - V8 10-18-2014, 11:30 AM
Replies: 214
Views: 16,107
Posted By Missile Man
Need assistance on installing my Apex catch can...

Need assistance on installing my Apex catch can with the maggie. I'm in the middle installing and am not sure how to proceed with the connections.

The catch can instructions are for a non-FI...
Forum: Forced Induction - V8 10-15-2014, 04:32 PM
Replies: 214
Views: 16,107
Posted By Missile Man
Yes, stock Maggie pulley, LS9 injectors and a RDS...

Yes, stock Maggie pulley, LS9 injectors and a RDS phenolic spacer ~1/2 in.
Forum: Forced Induction - V8 10-15-2014, 09:13 AM
Replies: 214
Views: 16,107
Posted By Missile Man
My SC install took longer than expected due to...

My SC install took longer than expected due to the issues I ran into. I'm back to work and it could be a while before I get dyno'ed.

I'm looking for someone who has a similar configuration as my...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-13-2014, 08:40 AM
Replies: 33
Views: 1,589
Posted By Missile Man
I just ordered the Apex. Special offer comes with...

I just ordered the Apex. Special offer comes with free 6061 T6 aluminum alloy Push Loc™ fittings and -06 AN adapters. Has a large catch can and I like the hockey stick bracket.

The anadized is...
Forum: Forced Induction - V8 10-12-2014, 05:11 PM
Replies: 214
Views: 16,107
Posted By Missile Man
Have an Apex catch can on order. $189.99 with...

Have an Apex catch can on order. $189.99 with free 6061 T6 aluminum alloy Push Loc™ fittings and -06 AN adapters included.
Forum: Forced Induction - V8 10-12-2014, 04:52 PM
Replies: 4
Views: 564
Posted By Missile Man
I decided to go with the Apex. Price is $189.99...

I decided to go with the Apex.
Price is $189.99 with free 6061 T6 aluminum alloy Push Loc™ fittings and -06 AN adapters.
Showing results 1 to 30 of 483

 
Forum Jump

All times are GMT -5. The time now is 10:05 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2015, vBulletin Solutions, Inc.