Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Gen5DIY
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 500
Search took 0.13 seconds.
Search: Posts Made By: Iam Broke
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-22-2015, 10:38 AM
Replies: 1
Views: 116
Posted By Iam Broke
That's what the ZL1 FPCM programming is. You are...

That's what the ZL1 FPCM programming is. You are fine.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 04-09-2015, 08:38 AM
Replies: 1
Views: 307
Posted By Iam Broke
Make an offer

Make an offer
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 04-07-2015, 05:19 PM
Replies: 3
Views: 477
Posted By Iam Broke
Sold!

Sold!
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 04-07-2015, 05:33 AM
Replies: 3
Views: 477
Posted By Iam Broke
Yes it is.

Yes it is.
Forum: Tuning / Diagnostics -- engine and transmission 04-02-2015, 12:21 PM
Replies: 5
Views: 326
Posted By Iam Broke
There is more to scaling that large of an...

There is more to scaling that large of an injector to your setup. The limitations of the ECU require you to scale the tune. MAF and VE need to be scaled as well as the injector data. Not a good...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-31-2015, 08:47 PM
Replies: 10
Views: 395
Posted By Iam Broke
Are the factory clamps leaking post cat? If so...

Are the factory clamps leaking post cat? If so Permatex makes a muffler tailpipe sealer paste that'll take care of it.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-23-2015, 08:54 AM
Replies: 8
Views: 296
Posted By Iam Broke
With your mods the stock pump dropping to 52 psi...

With your mods the stock pump dropping to 52 psi or so is normal. Not a big deal and can be tuned out for NA engines. Find out how far it drops wot before throwing money at it. ADM sells the ZL1 pump...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-02-2015, 10:08 AM
Replies: 4
Views: 208
Posted By Iam Broke
Perhaps you need to rotate the assembly a bit,...

Perhaps you need to rotate the assembly a bit, the lines & electrical connector aren't in the exact location as the stock ones but they will reach and connect.

Make sure the hat compresses all the...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 02-20-2015, 07:32 PM
Replies: 3
Views: 282
Posted By Iam Broke
No man, went back almost stock. Company went on...

No man, went back almost stock. Company went on strike and need the cash. Threw two rods last fall on a test hit, shrapnel took out the blower too. New ls3 long block before this strike happened....
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 02-20-2015, 07:22 AM
Replies: 3
Views: 282
Posted By Iam Broke
SOLD!

SOLD!
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 02-19-2015, 10:00 AM
Replies: 3
Views: 282
Posted By Iam Broke
FS: Livernois Twin Dual Fuel Pump - Drop In

Livernois Twin Fuel Pump, rated to 800whp on their website. Direct drop in on stock FPCM. Includes fuel gauge sending unit and float. No splicing or cutting lines. Used 1 season, approx. 2k miles.
...
Forum: Tuning / Diagnostics -- engine and transmission 02-02-2015, 10:10 AM
Replies: 3
Views: 328
Posted By Iam Broke
Same issue when I tried one as above, save your...

Same issue when I tried one as above, save your money unless you have access to a TechII on a regular basis. Pay to play when tuned.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-31-2015, 03:33 PM
Replies: 14
Views: 648
Posted By Iam Broke
Yes they are and work well on the LS3. Keeps the...

Yes they are and work well on the LS3. Keeps the torque down low and helps HP up top. Gain under the curve the whole way. Had them 2 years now, very pleased. Had them coated matte black from Maryland...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-25-2015, 09:33 PM
Replies: 84
Views: 3,672
Posted By Iam Broke
Ditch the oem piece and run a piece of 3/8" hose...

Ditch the oem piece and run a piece of 3/8" hose from the CAI MAF tube fitting to the rocker cover.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-25-2015, 05:44 PM
Replies: 84
Views: 3,672
Posted By Iam Broke
With 3/8" hose from the MAF tube nipple. I think...

With 3/8" hose from the MAF tube nipple. I think you have some things mixed up. Stock routing as I recall is pass rocker cover to MAF tube, Valley cover nipple to vac connection near TB with a U...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-25-2015, 02:38 PM
Replies: 3
Views: 293
Posted By Iam Broke
Sh!t, forgot all about this. It's 5 1/2"...

Sh!t, forgot all about this. It's 5 1/2" long.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-23-2015, 06:14 PM
Replies: 3
Views: 293
Posted By Iam Broke
I'm at work but have one at home in the drawer, I...

I'm at work but have one at home in the drawer, I can post up tomorrow if no one else does. You can have it if you need it. I mounted mine to the CAI airbox.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-21-2015, 04:50 AM
Replies: 84
Views: 3,672
Posted By Iam Broke
Yes you do. Raise it up a half inch or so with...

Yes you do. Raise it up a half inch or so with the bolts loose and held up then move the mani forward an inch or so for the bolts to clear the cowl.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-20-2015, 07:34 PM
Replies: 84
Views: 3,672
Posted By Iam Broke
On my 2012 I had to remove the brackets at the...

On my 2012 I had to remove the brackets at the rear of the intake mani so it would clear the pressure tap when the rail was flipped. (actually, only the pass side but I pulled them both off)

I...
Forum: Tuning / Diagnostics -- engine and transmission 01-20-2015, 08:19 AM
Replies: 5
Views: 636
Posted By Iam Broke
You can fake it out by limiting the revs tho, RPM...

You can fake it out by limiting the revs tho, RPM limit vs wheel speed. I limit mine to 3k at 0 mph & ramp up. Engine tab, Cutoff DFCO.

Applies to all modes, not just comp mode.
Forum: Camaro DIY & HOW-TO instructions & discussions 01-10-2015, 01:47 PM
Replies: 30
Views: 1,281
Posted By Iam Broke
Yep, then once the coil packs are off, the...

Yep, then once the coil packs are off, the brackets can be removed and the rocker covers unbolted.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-31-2014, 06:07 PM
Replies: 3
Views: 477
Posted By Iam Broke
JRE/Metco checked breather for Holley, ect.

Cleaning out the garage...

JRE modified Metco valve cover breather for 2010-2015 aftermarket valve covers such as Holley with the threaded opening.

Used 1 season.

Metco breather has been...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-31-2014, 06:01 PM
Replies: 1
Views: 307
Posted By Iam Broke
K&N drop in 33-2434

Cleaning out the garage...
Used ~1000 miles. $30 shipped. PM me for paypal info.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-28-2014, 05:02 AM
Replies: 17
Views: 1,345
Posted By Iam Broke
SOLD!

SOLD!
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-27-2014, 07:51 AM
Replies: 17
Views: 1,345
Posted By Iam Broke
Still for sale. $400 shipped.

Still for sale. $400 shipped.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-26-2014, 06:57 AM
Replies: 14
Views: 1,275
Posted By Iam Broke
Solo has a set for the GFX too, I went with those...

Solo has a set for the GFX too, I went with those on their j-pipe catback. No pix, sorry but you don't even see the tips unless you look, they are about 1/2" recessed in the GFX openings.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-13-2014, 03:04 PM
Replies: 4
Views: 882
Posted By Iam Broke
You're welcome, thanks for the feedback.

You're welcome, thanks for the feedback.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-13-2014, 09:58 AM
Replies: 17
Views: 1,345
Posted By Iam Broke
Good winter project. Weekend bump.

Good winter project. Weekend bump.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-09-2014, 05:23 AM
Replies: 17
Views: 1,345
Posted By Iam Broke
Thanks for posting that, I would have but I...

Thanks for posting that, I would have but I forgot the stock lift numbers.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-05-2014, 02:51 PM
Replies: 4
Views: 882
Posted By Iam Broke
SOLD!

SOLD!
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 09:30 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.