Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Kraft Werks
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 99
Search took 0.02 seconds.
Search: Posts Made By: granatl
Forum: Tuning / Diagnostics -- engine and transmission Today, 02:09 AM
Replies: 1
Views: 102
Posted By granatl
I had that warning before too. In my case, the...

I had that warning before too. In my case, the one connector fell off the temperature sensor. It's that sensor near the #1 spark plug (behind the power steering pump on the driver's side head).
Forum: Forced Induction - V8 10-03-2014, 06:47 PM
Replies: 16
Views: 670
Posted By granatl
I added a KB BAP to mine and really never noticed...

I added a KB BAP to mine and really never noticed much of a difference.
Changing the "Fuel System Minimum Voltage" parameters in the ECU seemed to have more of a positive effect.
Forum: Forced Induction - V8 09-16-2014, 08:18 PM
Replies: 22
Views: 913
Posted By granatl
I also like Amsoil and will add some ZDDP. It's...

I also like Amsoil and will add some ZDDP. It's important to know that zinc helps protect in higher HP engines, but also damages catalytic converters.
Forum: Camaro V6 LFX Engine, Exhaust, and Bolt-Ons 09-02-2014, 10:30 PM
Replies: 10
Views: 681
Posted By granatl
I know most is crap, but I've known several...

I know most is crap, but I've known several people swear that Torco is the real deal....
Forum: Tuning / Diagnostics -- engine and transmission 08-27-2014, 07:36 PM
Replies: 7
Views: 921
Posted By granatl
Maybe take a look at the open loop (P/N) table....

Maybe take a look at the open loop (P/N) table. The car should be running in O/L for like 10 seconds (after jumping from the cranking table) before it sees if everything is ready to jump into C/L.
...
Forum: Forced Induction - V8 08-25-2014, 08:41 PM
Replies: 7
Views: 599
Posted By granatl
Injectors are typically easy to change. IDK how...

Injectors are typically easy to change. IDK how much complexity the supercharger adds though.

However, if you're changing the size (flowrate) of them, you have to be able to re-flash your...
Forum: Tuning / Diagnostics -- engine and transmission 08-16-2014, 11:15 PM
Replies: 5
Views: 690
Posted By granatl
1) As long as it takes for either (a) the...

1) As long as it takes for either (a) the histogram to reach pretty much a steady state (cells are only changing by .1-.3) or (b) correcting those cells that are >10% on either side of zero. Drive...
Forum: Tuning / Diagnostics -- engine and transmission 08-16-2014, 09:09 PM
Replies: 14
Views: 1,532
Posted By granatl
As stated, always target 0 KR. >0 hammers on the...

As stated, always target 0 KR. >0 hammers on the bearings and reduces the life of your engine. The computer is being reactionary -- i.e. it's trying to prevent continuing a problem that has occurred...
Forum: Tuning / Diagnostics -- engine and transmission 08-16-2014, 08:53 PM
Replies: 5
Views: 690
Posted By granatl
At least on the 2010-2013 v8's, these cars use a...

At least on the 2010-2013 v8's, these cars use a E38 computer.
They do not contain VE tables, but rather key data points and then use formulas to derive a VE cell on-demand. Mind you, I don't recall...
Forum: Forced Induction - V8 07-07-2014, 10:06 PM
Replies: 10
Views: 701
Posted By granatl
Any recommendations for aftermarket balancer?

The harmonic balancer came off my engine. I don't think it harmed the Callies crank, but the balancer certainly is scrap metal now

Has anyone gone to any of the aftermarket ones? Did you add a key...
Forum: Suspension / Brakes / Chassis 07-03-2014, 05:55 PM
Replies: 10
Views: 753
Posted By granatl
Knock on wood, but no more leaks for me.

Knock on wood, but no more leaks for me.
Forum: Forced Induction - V8 06-10-2014, 10:55 PM
Replies: 4
Views: 355
Posted By granatl
Thanks for sharing! I'll try a richer mixture and...

Thanks for sharing! I'll try a richer mixture and see how that goes for me.
Forum: Forced Induction - V8 06-10-2014, 07:36 AM
Replies: 4
Views: 355
Posted By granatl
I'm surprised that you're running it that rich. ...

I'm surprised that you're running it that rich.
I do have a wideband, and am shooting for .85 lambda (1.17-1.18). I can't seem to get steady values though. Regardless of WOT or idling, I have times...
Forum: Forced Induction - V8 06-09-2014, 09:34 PM
Replies: 4
Views: 355
Posted By granatl
KB BAP + Twin FP's

All this is butt dyno...

I have twin stock SS fuel pumps. I run e85 with a single large turbo at 10 PSI, etc. This is a heavily modded motor. Maybe high 600's at the crank. FAST 85# injectors...
Forum: Forced Induction - V8 06-08-2014, 09:09 PM
Replies: 2
Views: 282
Posted By granatl
Have you free-air re-calibrated your wideband O2...

Have you free-air re-calibrated your wideband O2 lately? Are you running leaded gas that will kill it?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2014, 11:10 PM
Replies: 1
Views: 185
Posted By granatl
fan connector partially melted, no low fan

The square connector for the two cooling fans has partially melted inside the connector. The driver side (DS) fan wiring has gotten so hot, that it actually melted the plastic insulation around the...
Forum: Forced Induction - V8 04-26-2014, 09:06 AM
Replies: 31
Views: 903
Posted By granatl
This thread caught my eye since I'm running into...

This thread caught my eye since I'm running into the same thing! Twin ADM's, FAST 85#, e85, ~10 PSI and I swear I'm running out of fuel! I'm putting it on a dyno in a couple of hours, but with soft...
Forum: Forced Induction - V8 04-21-2014, 10:09 PM
Replies: 3
Views: 247
Posted By granatl
A year or so ago, I DID have a drain problem that...

A year or so ago, I DID have a drain problem that caused that same type of smoking. I haven't had a problem until I added the CC. I can revert back to the way it was, if need be. The turbo...
Forum: Forced Induction - V8 04-21-2014, 09:16 PM
Replies: 3
Views: 247
Posted By granatl
Catch can with turbo?

I put on a catch can with my turbo LS2 setup this past weekend. However, it's not working as expected because after returning to vacuum from boost, the car smokes like hell until it burns off the...
Forum: Transmission / Driveline 04-14-2014, 11:41 AM
Replies: 3
Views: 237
Posted By granatl
I just changed axles in my 2010 SS. I have the...

I just changed axles in my 2010 SS. I have the stock pair sitting in my garage (21k miles on them). You can PM me an offer.
Forum: Suspension / Brakes / Chassis 04-11-2014, 07:29 PM
Replies: 10
Views: 753
Posted By granatl
I thought they were symmetric (unlike the stock...

I thought they were symmetric (unlike the stock ones), so I managed to flip-flop sides. So, when I correct this, it should stop the leaking.
Forum: Suspension / Brakes / Chassis 04-11-2014, 07:21 PM
Replies: 10
Views: 753
Posted By granatl
Just in case someone comes across this post in...

Just in case someone comes across this post in the future...

The thinner tube (1.22") is the slightly longer axle and it goes on the driver's side.
The thicker tube (1.38") is the slightly...
Forum: Suspension / Brakes / Chassis 04-10-2014, 09:44 PM
Replies: 10
Views: 753
Posted By granatl
axle seals leaking with GForce axles

OK, I'm missing something or other. I'm on my 3rd seal on the driver's side and it's still leaking now that I put in the GForce axles. The passenger side seems slightly damp, but not to the degree of...
Forum: Tuning / Diagnostics -- engine and transmission 04-07-2014, 05:50 PM
Replies: 4
Views: 373
Posted By granatl
It'd be easier just to switch to the red label...

It'd be easier just to switch to the red label 2.5 bar MAP sensor (and change the computer parameters for it), as that's already a sensor in HPT.
Forum: Suspension / Brakes / Chassis 04-04-2014, 08:24 PM
Replies: 4
Views: 212
Posted By granatl
thanks!

thanks!
Forum: Suspension / Brakes / Chassis 04-04-2014, 07:39 PM
Replies: 4
Views: 212
Posted By granatl
axle seal orientation

On the axle seal that goes into the differential, what is the orientation?
1. spring-lip faces inside diff.
2. spring-lip faces outside diff.
Forum: Suspension / Brakes / Chassis 04-03-2014, 07:58 PM
Replies: 2
Views: 159
Posted By granatl
Thanks for the lightning fast reply! I was...

Thanks for the lightning fast reply! I was thinking about grabbing Royal Purple from the auto parts store or Amsoil (since we have a warehouse locally). So, if I use quality synth., I don't need posi...
Forum: Suspension / Brakes / Chassis 04-03-2014, 07:49 PM
Replies: 2
Views: 159
Posted By granatl
Need directions for changing IRS axle seal

I put in heavy duty rear axles and must've sliced the seal on one side, as it's leaking differential fluid. I have a new seal and the axle is already removed. What does is take to pull the old seal...
Forum: Forced Induction - V8 04-03-2014, 12:43 PM
Replies: 25
Views: 1,747
Posted By granatl
Should you want to do the ARP studs, I have a...

Should you want to do the ARP studs, I have a used set. We couldn't use them in my new LS2 motor.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-28-2014, 03:41 PM
Replies: 78
Views: 4,360
Posted By granatl
The Flex Fuel sensor compensates for that. As the...

The Flex Fuel sensor compensates for that. As the alky ratio decreases, the interpolation goes more towards favoring the gas tables.

In the winter, they commonly do make it 70% to make cars start...
Showing results 1 to 30 of 99

 
Forum Jump

All times are GMT -5. The time now is 04:33 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.