Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
B&M
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 24 of 24
Search took 0.01 seconds.
Search: Posts Made By: D3R3K
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-24-2015, 04:50 PM
Replies: 51
Views: 1,331
Posted By D3R3K
Was the engine cold when you started the oil...

Was the engine cold when you started the oil change? Did you have the oil cap off and the dip stick pulled to aid in draining? Sounds like you didnt let it drain long enough.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-24-2015, 03:43 PM
Replies: 51
Views: 1,331
Posted By D3R3K
Is the angle of your ramps keeping all the oil...

Is the angle of your ramps keeping all the oil from draining out of the pan? I let the oil and filter housing drain for 30 mins on a flat surface. If your oil level is too high it can damage your...
Forum: Transmission / Driveline 01-06-2015, 10:34 PM
Replies: 16
Views: 631
Posted By D3R3K
That was in 100 degree temps in Texas and i had...

That was in 100 degree temps in Texas and i had to lift in 2nd due to the track being greasy.
Forum: Forced Induction - V8 01-06-2015, 10:30 PM
Replies: 89
Views: 6,673
Posted By D3R3K
What size are the down pipes? Will these turbos...

What size are the down pipes? Will these turbos make over 1k hp with a built bottom end?
Forum: Transmission / Driveline 01-05-2015, 11:04 AM
Replies: 16
Views: 631
Posted By D3R3K
10.40's @135 1.58 60ft.

10.40's @135 1.58 60ft.
Forum: Transmission / Driveline 01-05-2015, 01:54 AM
Replies: 16
Views: 631
Posted By D3R3K
Ive got the mantic single disk with over 800hp...

Ive got the mantic single disk with over 800hp and M&H 325 tires. The clutch still holds fine on the street and strip.
Forum: Dragstrip and Launch Techniques Discussion 08-27-2014, 12:07 AM
Replies: 56
Views: 3,729
Posted By D3R3K
I did 158 on stock pzero tires at the half mile...

I did 158 on stock pzero tires at the half mile shootout Horseshoe bay.
Forum: Forced Induction - V8 08-02-2014, 12:44 AM
Replies: 27
Views: 3,260
Posted By D3R3K
I have a similar set up from LG and this combo...

I have a similar set up from LG and this combo runs hard!
G6X3
LG Long tubes
LG Full exhaust
Procharger F1A

750+hp on pump gas with no meth!
Forum: Dragstrip and Launch Techniques Discussion 06-03-2014, 09:21 PM
Replies: 335
Views: 39,846
Posted By D3R3K
http://i61.tinypic.com/awoqw4.jpg Did this at...

http://i61.tinypic.com/awoqw4.jpg Did this at Camaro Fest.
60 ft/time: 1.828

Tire Brand/Type: Stock PZERO

Tire Size: 275/40/20

Suspension Upgrades:Eibach lowering springs

Drivetrain...
Forum: Forced Induction - V8 05-17-2014, 11:00 PM
Replies: 19
Views: 936
Posted By D3R3K
Get an Procharger f1 or bigger. My car just makes...

Get an Procharger f1 or bigger. My car just makes 750 on pump with a G6X3 cam that has a lot of overlap. I make over 800 on race gas. No meth!
Forum: Forced Induction - V8 04-08-2014, 10:28 PM
Replies: 20
Views: 1,411
Posted By D3R3K
LG Catch can http://i60.tinypic.com/11acya9.jpg

LG Catch can
http://i60.tinypic.com/11acya9.jpg
Forum: Forced Induction - V8 04-08-2014, 09:24 AM
Replies: 3
Views: 638
Posted By D3R3K
F1A with a 5" pulley im at 12.8 psi @ 6700. 12*...

F1A with a 5" pulley im at 12.8 psi @ 6700. 12* of timing got me 757 rwhp. We could have easily added timing and went over 800. Im not currently trying to max out my clutch so we left it safe.
Forum: Forced Induction - V8 04-06-2014, 11:06 PM
Replies: 81
Views: 4,312
Posted By D3R3K
A. I was struggling with the same choice....

A.
I was struggling with the same choice. Procharger all the way! Just make sure you get the F series if u want to make big power.
Forum: Forced Induction - V8 04-05-2014, 12:48 AM
Replies: 25
Views: 1,273
Posted By D3R3K
Top of 4th with stock m6 trans, rear end and...

Top of 4th with stock m6 trans, rear end and tires is 170+
Forum: Forced Induction - V8 03-29-2014, 04:33 PM
Replies: 237
Views: 91,696
Posted By D3R3K
2010 Camaro SS M6- Stock bottom end/ Stock heads ...

2010 Camaro SS M6- Stock bottom end/ Stock heads

Procharger F1A @12.8 Psi
Big intercooler, Inlet upgrade, 12 rib, race valve
ATi Damper w/12 rib
LPE twin fuel pumps
Id 850 Injectors
LG G6X3...
Forum: Forced Induction - V8 03-13-2014, 09:38 PM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
Got her on the dyno at the last minute before...

Got her on the dyno at the last minute before tx2k14. Still have power left on the table by adding meth and changing to 1 7/8 long tubes and 3 inch exhaust. I'm happy with where it's at currently....
Forum: Forced Induction - V8 03-09-2014, 01:34 AM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
Making progress. It's taking time to get...

Making progress. It's taking time to get everything to fit just right, it's been a pretty fun install to this point. Sucks that my ati balancer was delayed. It's about to be a serious time crunch to...
Forum: Forced Induction - V8 03-06-2014, 10:20 PM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
Ive got everything but the ATi balancer. Im...

Ive got everything but the ATi balancer. Im hoping to have it done by the end of this weekend. This is a lot of parts! I can't wait till it's tuned and ready to go.
http://i58.tinypic.com/vikx2c.jpg...
Forum: Forced Induction - V8 03-01-2014, 02:08 PM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
I hoping a 5" up top will limit the boost to...

I hoping a 5" up top will limit the boost to 10-11psi.
Forum: Forced Induction - V8 03-01-2014, 12:22 AM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
Dyno Jet. And I definitely forgot 650-700

Dyno Jet. And I definitely forgot 650-700
Forum: Forced Induction - V8 02-28-2014, 11:06 PM
Replies: 11
Poll: Guess the HP
Views: 806
Posted By D3R3K
Guess the HP

Some time next week all my parts will be in. I've read several other threads with similar builds and the hp varies 100-200hp. I've wanted boost for a long time. I plan on building a built bottom end...
Forum: Forced Induction - V8 02-28-2014, 11:05 PM
Replies: 0
Views: 228
Posted By D3R3K
Forum: Forced Induction - V8 02-28-2014, 09:56 PM
Replies: 18
Views: 1,481
Posted By D3R3K
I have a set on the way. Can't wait.

I have a set on the way. Can't wait.
Forum: 5th Gen Camaro SS LS LT General Discussions 11-09-2013, 03:02 PM
Replies: 45
Views: 4,623
Posted By D3R3K
I went 171.6 in 4th a few weeks back. ...

I went 171.6 in 4th a few weeks back.
TEaAwZ4F6dU
Showing results 1 to 24 of 24

 
Forum Jump

All times are GMT -5. The time now is 04:44 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.