Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Bigwormgraphix
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 25 of 25
Search took 0.03 seconds.
Search: Posts Made By: JWG
Forum: 5th Gen Camaro SS LS LT General Discussions 05-24-2014, 08:54 AM
Replies: 13
Views: 1,307
Posted By JWG
Looks similar to a bolt on she starter.

Looks similar to a bolt on she starter.
Forum: Forced Induction - V8 12-06-2013, 06:06 PM
Replies: 153
Views: 5,561
Posted By JWG
Shouldn't boost reference come off the small...

Shouldn't boost reference come off the small nipple by the MAP sensor? The brake booster vacuum is before the rotors so not sure you would see boost there.
Forum: Dragstrip and Launch Techniques Discussion 03-17-2013, 02:11 PM
Replies: 2,659
Views: 342,120
Posted By JWG
Thanks. I was just pointing out that the 1/8 mile...

Thanks. I was just pointing out that the 1/8 mile mph on this time slip is not correct. I wish it would do 111 mph in the 1/8. Maybe someday.
Forum: Dragstrip and Launch Techniques Discussion 03-16-2013, 01:30 PM
Replies: 2,659
Views: 342,120
Posted By JWG
New Best. 1/8 mph is not correct Tires used...

New Best. 1/8 mph is not correct

Tires used on the pass: Slicks, Skinnies
Performance Mods (if any): TVS 2300 Maggie Max, LT, Cam, CAI, Converter, Gears
Category submitted for: Camaro SS, Power...
Forum: USA - Texas 01-12-2013, 06:40 PM
Replies: 13
Views: 958
Posted By JWG
Already been mentioned but you can't go wrong...

Already been mentioned but you can't go wrong with a remote tune by Jannetty.
Forum: Forced Induction - V8 11-22-2012, 08:43 AM
Replies: 13
Views: 668
Posted By JWG
http://www.camaro5.com/forums/showthread.php?t=257...

http://www.camaro5.com/forums/showthread.php?t=257877&page=4

Check out post #95. That's where this should plug in unless you removed AFM.
Forum: Forced Induction - V8 11-22-2012, 08:15 AM
Replies: 13
Views: 668
Posted By JWG
Looks like the plug for AFM that goes to the back...

Looks like the plug for AFM that goes to the back of the valley cover. Is this a L99 with AFM removed?
Forum: Dragstrip and Launch Techniques Discussion 11-03-2012, 09:04 PM
Replies: 2,659
Views: 342,120
Posted By JWG
Tires used on the pass: Slicks, Skinnies ...

Tires used on the pass: Slicks, Skinnies
Performance Mods (if any): TVS 2300 Maggie Max, LT, Cam, CAI, Converter, Gears
Category submitted for: Camaro SS, Power Adder, Stock Displacement...
Forum: Tuning / Diagnostics -- engine and transmission 10-19-2012, 09:47 AM
Replies: 87
Views: 5,356
Posted By JWG
Just received this from SCT Tech Support. ...

Just received this from SCT Tech Support.

"we do have the issue resolved with that error on the itsx however now we have to wait on apple, there is a new app version that goes along with the fix...
Forum: Tuning / Diagnostics -- engine and transmission 10-13-2012, 02:27 PM
Replies: 87
Views: 5,356
Posted By JWG
When I upload stock it goes through the process,...

When I upload stock it goes through the process, unlocks the ecu, acts like its uploading then when the red bar gets full it gives an error message.
Forum: Tuning / Diagnostics -- engine and transmission 10-13-2012, 01:18 PM
Replies: 87
Views: 5,356
Posted By JWG
I have tried an iPhone and iPad with iOS5 and an...

I have tried an iPhone and iPad with iOS5 and an iPhone with ios 6. I can communicate with the itsx and even data log with it just can't load a tune onto the car. Getting the "failed to select custom...
Forum: Dragstrip and Launch Techniques Discussion 08-12-2012, 09:58 PM
Replies: 620
Views: 66,357
Posted By JWG
2SS/RS w/L99 Class: Power adder Tires used on...

2SS/RS w/L99
Class: Power adder
Tires used on the pass: 17" hoosier slicks
Performance Mods (if any): TVS 2300, OD Cog, JRE cam, LS3 conversion, 2600 stall converter
R/T: 1.1818
60': 1.6348...
Forum: Forced Induction 08-05-2012, 11:14 PM
Replies: 4
Views: 1,186
Posted By JWG
FS: ZL 1 fuel pump and MSD fuel pump voltage booster

Used ZL-1 fuel pump - sold and shipped

Used MSD programmable voltage booster (#2351)- sold

Upgraded LPE dual pump so don't need these anymore.
Forum: Dragstrip and Launch Techniques Discussion 07-22-2012, 11:01 PM
Replies: 34
Views: 1,366
Posted By JWG
The 325's will fit. I'm running them with the...

The 325's will fit. I'm running them with the weld 17" wheels. I don't see a huge difference vs running slicks on my car.
Forum: Forced Induction - V8 07-20-2012, 11:19 PM
Replies: 15
Views: 1,273
Posted By JWG
Boost is usually measured in psi and vacuum is...

Boost is usually measured in psi and vacuum is usually inHg. Could it just be different units?
Forum: Forced Induction - V8 06-21-2012, 12:38 PM
Replies: 20
Views: 1,569
Posted By JWG
Missing the idler pulley that bolts to the...

Missing the idler pulley that bolts to the Maggie? You probably just took the picture before you put it on but wanted to point it out just in case.
Forum: Forced Induction - V8 06-19-2012, 06:45 PM
Replies: 9
Views: 1,224
Posted By JWG
I've had the same code pop up a few times. I just...

I've had the same code pop up a few times. I just clear it with my SCT and move on. Hasn't come back lately.
Forum: Wheels / Tires 04-08-2012, 08:16 AM
Replies: 5
Views: 813
Posted By JWG
Pm sent.

Pm sent.
Forum: Forced Induction - V8 02-22-2012, 08:56 PM
Replies: 13
Views: 1,142
Posted By JWG
Honestly I haven't driven much since I put the...

Honestly I haven't driven much since I put the cam in but i do like it. About 300 miles and I've been working with Ted on the email tune. Have that dialed in now so maybe I'll drive a little more if...
Forum: Forced Induction - V8 02-21-2012, 07:50 PM
Replies: 13
Views: 1,142
Posted By JWG
I think that was idling 650-700 rpm. I'll check...

I think that was idling 650-700 rpm. I'll check again when i get a chance.
Forum: Forced Induction - V8 02-20-2012, 09:45 PM
Replies: 13
Views: 1,142
Posted By JWG
This is the JRE rough idle blower cam. ...

This is the JRE rough idle blower cam.

xdJcuE7_uX8
Forum: Forced Induction - V8 02-02-2012, 12:39 PM
Replies: 2
Views: 576
Posted By JWG
Maybe this? Static Flow Rate @ 58.0PSI...

Maybe this?

Static Flow Rate @ 58.0PSI (300kPa): 39.0 lb/hr = 6.52g/s = 409.5cc/mn

Cross Reference:
Bosch 0 280 158 051 (0280158051)
GM# 12576341
Forum: Forced Induction - V8 11-29-2011, 08:24 PM
Replies: 31
Views: 1,501
Posted By JWG
Oil in the supercharger is clear. At least it was...

Oil in the supercharger is clear. At least it was on mine. If you look toward the back of the supercharger under the belt do you see or feel any oil? Mine had a leak in this area but it was small....
Forum: Forced Induction - V8 11-24-2011, 12:03 PM
Replies: 3
Views: 414
Posted By JWG
Look on the magna charger website. It's on there...

Look on the magna charger website. It's on there as a PDF file.
Forum: Dragstrip and Launch Techniques Discussion 08-02-2011, 09:33 PM
Replies: 23
Views: 1,395
Posted By JWG
I bought some factory c6 z06 wheels from a place...

I bought some factory c6 z06 wheels from a place on amazon. 18x9.5" with 40 mm offset. They work great so far and the price was better than anything else I have seen, even the replicas. Makes me...
Showing results 1 to 25 of 25

 
Forum Jump

All times are GMT -5. The time now is 03:43 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.