Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 2 1 2
Showing results 1 to 30 of 53
Search took 0.01 seconds. Search: Posts Made By: GhOsT_2SS
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-12-2013, 12:25 AM
Replies: 18
Views: 6,936
Posted By GhOsT_2SS
Well not sure if your thanking me, but your...

Well not sure if your thanking me, but your welcome. No issues so far with the rest of the dash kit. Like I said before I traced the front speaker wiring going to the 20 pin connector then it goes...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-05-2013, 03:09 PM
Replies: 18
Views: 6,936
Posted By GhOsT_2SS
Pulled the harness out and cut the zip ties to...

Pulled the harness out and cut the zip ties to follow the wires. Sure enough if I had a bypass connector the front speakers would work. I did not receive one. This harness has the front speaker...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-05-2013, 02:30 PM
Replies: 18
Views: 6,936
Posted By GhOsT_2SS
Ok, I tried more last night to pin point my...

Ok, I tried more last night to pin point my search and figured the onstar separate harness shouldn't affect my issue. So going to run swap my speaker wiring and check the scosche harness for possible...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 10-04-2013, 11:03 PM
Replies: 18
Views: 6,936
Posted By GhOsT_2SS
Scosche GM5201AB just installed, Front speakers dont work

Alright, car is a 2011 2SS with BA system and just installed the new scosche gm5201ab kit and a Kenwood Excelon DNX690HD. Went through the initial start up of the hvac and stereo install. I have no...
Forum: USA - Texas 08-04-2013, 05:01 PM
Replies: 3
Views: 1,491
Posted By GhOsT_2SS
It was a 5th Gen, car was covered in Monster...

It was a 5th Gen, car was covered in Monster energy graphics. Sounded like it had a cam for sure.
Forum: USA - Texas 08-04-2013, 02:34 PM
Replies: 3
Views: 1,491
Posted By GhOsT_2SS
Monster Energy Convertible Camaro in Killeen

Wondering if its someone around here in Killeen that owns the Monster Energy Convertible Camaro I just saw in Killeen. I pasted in on WS Young near the mall. Nice sounding car.
Forum: ZL1 Engine, Exhaust, and Bolt-Ons 07-27-2013, 11:02 AM
Replies: 48
Views: 7,599
Posted By GhOsT_2SS
Need one for a LS3

Need one for a LS3
Forum: USA - Texas 07-17-2013, 09:46 PM
Replies: 2,130
Views: 360,484
Posted By GhOsT_2SS
Just moved back to Texas, in the Killeen/Harker...

Just moved back to Texas, in the Killeen/Harker Heights area. San Antonio is home and great to be back.

http://imageshack.us/a/img38/2407/g9vv.JPG
http://imageshack.us/a/img534/197/6jmb.jpg
Forum: Autos For Sale / Wanted 05-22-2013, 10:32 PM
Replies: 7
Views: 2,268
Posted By GhOsT_2SS
Nice, any interest in parting it out and swapping...

Nice, any interest in parting it out and swapping in trade with stock parts. I love the wheels. Just asking if you'd part out the springs, sway bars and wheels and tires, paying you a reasonable...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-21-2013, 09:41 PM
Replies: 29
Views: 5,004
Posted By GhOsT_2SS
I had Performance Coatings do mine also, only a 5...

I had Performance Coatings do mine also, only a 5 day turn around. No reason to wait on weather to install them. This is Washington and the weather seems to always stay the same. So get it done.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-20-2013, 11:53 PM
Replies: 0
Views: 1,361
Posted By GhOsT_2SS
Kenwood Dashkit dead, idatalink Onstar intergration still alive

Well after reading the Kenwood dash kit may be dead and not happy with present selections of dash kits available. I like this http://www.camaro5.com/forums/showthread.php?t=42923 its perfect but not...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-20-2013, 10:43 PM
Replies: 29
Views: 5,004
Posted By GhOsT_2SS
True bare stainless isn't going to rust or...

True bare stainless isn't going to rust or corrode, I just think ceramic coated just makes the install a finished completed product. Maybe some pics will help, I think I waited about 4 weeks before...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-10-2013, 10:03 PM
Replies: 22
Views: 4,039
Posted By GhOsT_2SS
Good point, I do this myself also. To easy with...

Good point, I do this myself also. To easy with the way filter installs. I poor in about a half a quart into the filter.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-09-2013, 12:07 AM
Replies: 22
Views: 4,039
Posted By GhOsT_2SS
I have heard nothing but horror stories about...

I have heard nothing but horror stories about jiffy lube or walmart oil changes, wrong filter installed, striped drain plugs, not to mention the shit dino oil they are going to put in your car. Or...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-08-2013, 11:54 PM
Replies: 8
Views: 1,429
Posted By GhOsT_2SS
I think the old ways of engine break in are not...

I think the old ways of engine break in are not needed, engines today are build to exact tolerances and are usually ran before they go into a car. Usually from what I have read is the break in is...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-08-2013, 10:37 PM
Replies: 27
Views: 3,060
Posted By GhOsT_2SS
patiently waiting for my RX for about 3 weeks now.

patiently waiting for my RX for about 3 weeks now.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 04-30-2013, 01:38 AM
Replies: 47
Views: 12,199
Posted By GhOsT_2SS
I hope kenwood comes through with a dash kit and...

I hope kenwood comes through with a dash kit and idata link. I do not like the current Scosche or Metra dash kits. They just seen so cheap and read they have issues. I currently have the Kenwood...
Forum: USA - Northwest / Pacific Northwest 04-30-2013, 01:20 AM
Replies: 11
Views: 2,441
Posted By GhOsT_2SS
on a 5th Gen? that would be a bit to much retro...

on a 5th Gen? that would be a bit to much retro old school classic for me
Forum: USA - Northwest / Pacific Northwest 04-30-2013, 01:11 AM
Replies: 25
Views: 2,391
Posted By GhOsT_2SS
70's awesome bring on the sun

70's awesome bring on the sun
Forum: Local Marketplace 04-03-2013, 01:53 PM
Replies: 7
Views: 2,140
Posted By GhOsT_2SS
Tempting, but I am saving for the Pfadt Stage 3...

Tempting, but I am saving for the Pfadt Stage 3 suspension. If you don't have a local sale of it soon let me know.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-30-2013, 12:36 AM
Replies: 305
Views: 72,533
Posted By GhOsT_2SS
Sounds good Apex, sold me to buy your product.

Sounds good Apex, sold me to buy your product.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-29-2013, 09:40 PM
Replies: 305
Views: 72,533
Posted By GhOsT_2SS
Interested in the same thing. A scoop is a scoop...

Interested in the same thing. A scoop is a scoop but quality of the combo is important. I don't want a made it China import that's going to break.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-28-2013, 09:20 PM
Replies: 15
Views: 5,343
Posted By GhOsT_2SS
mine was doing the same thing. I found that the...

mine was doing the same thing. I found that the AC belt started to walk off the AC compressor pulley and one heavy press of the gas I popped it off and it shredded the belt and wrapped itself behind...
Forum: USA - Northwest / Pacific Northwest 03-27-2013, 10:37 PM
Replies: 19
Views: 1,731
Posted By GhOsT_2SS
5:30 works for me

5:30 works for me
Forum: USA - Northwest / Pacific Northwest 03-26-2013, 09:24 PM
Replies: 19
Views: 1,731
Posted By GhOsT_2SS
Sure, why not. Didn't know there is a Greater...

Sure, why not. Didn't know there is a Greater Yelm Area. I know during the week I always see some nice classics that meet up in that parking lot. I usually miss them hanging out and always leaving...
Forum: USA - Northwest / Pacific Northwest 03-24-2013, 09:36 PM
Replies: 6
Views: 1,411
Posted By GhOsT_2SS
Oh yeah, nice meeting you guys too. Your times...

Oh yeah, nice meeting you guys too. Your times show what I could do with the suspension and right tires.
Forum: USA - Northwest / Pacific Northwest 03-24-2013, 09:34 PM
Replies: 6
Views: 1,411
Posted By GhOsT_2SS
Nope, just a few bolt-on and a tune. But a big...

Nope, just a few bolt-on and a tune. But a big wish list and not enough money.
Forum: USA - Northwest / Pacific Northwest 03-23-2013, 10:47 PM
Replies: 6
Views: 1,411
Posted By GhOsT_2SS
Went Racing, Pacific Raceways Test and Tune

Well it was a very nice day and first time taking the Camaro to the drag strip. I had high hopes to run a better time but with stock tires and annoying wheel hop I had my best run my second time...
Forum: USA - Northwest / Pacific Northwest 03-20-2013, 11:02 PM
Replies: 22
Views: 2,115
Posted By GhOsT_2SS
Looks like I be there with another Camaro owner...

Looks like I be there with another Camaro owner from work and another buddy with a M3. But I am really interested in the sports driving licensing. I have over 20 laps on the Nurburgring when I was...
Forum: USA - Northwest / Pacific Northwest 03-19-2013, 12:18 AM
Replies: 22
Views: 2,161
Posted By GhOsT_2SS
I am interested, don't think I can make them all...

I am interested, don't think I can make them all so might do some test and tune. Moving back to Texas in July.
Showing results 1 to 30 of 53
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 06:07 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.