Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Jason 98 TA
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 19 of 19
Search took 0.01 seconds.
Search: Posts Made By: mattderk
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 08-28-2012, 10:21 AM
Replies: 129
Views: 26,558
Posted By mattderk
2nd Pump

It is appearing that my replacement oil pump is crappingout also.

Had low pressure (down to 15) and dropped lifters so car is out of comission and need to pull heads and maybe another pump.
...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-28-2012, 04:41 PM
Replies: 29
Views: 1,516
Posted By mattderk
Sliced o-ring from factory when it got pulled...

Sliced o-ring from factory when it got pulled off. Still got stuck with the bill.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-27-2012, 03:54 PM
Replies: 143
Views: 20,278
Posted By mattderk
You can figure around $900 with labor from a...

You can figure around $900 with labor from a decent shop. Part is only $200'ish.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-27-2012, 03:50 PM
Replies: 29
Views: 1,516
Posted By mattderk
I will run below 30 at idle sometimes. Almost...

I will run below 30 at idle sometimes. Almost down to what I would guess is 20. When I first crank over and driving around 40-50 usually.

It is a ported performance GM LS5 oilpump. My first oil...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-30-2012, 11:12 PM
Replies: 82
Views: 6,276
Posted By mattderk
Or retrofit with a push starts :-)

Or retrofit with a push starts :-)
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 01-30-2012, 11:08 PM
Replies: 22
Views: 2,541
Posted By mattderk
Installed

I did the advanced keys 104b .. great system and no bypass module
Forum: Camaro DIY & HOW-TO instructions & discussions 01-30-2012, 11:06 PM
Replies: 158
Views: 32,649
Posted By mattderk
Installed ...system under $400

advaned keys 104b system ... great setup
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 01-30-2012, 11:02 PM
Replies: 85
Views: 18,166
Posted By mattderk
Installed

I did the advanced keys 104B install. its great...just dont use a bypass module, hard wire it ! It saves you from getting locked out of the car incase the bypass module goofs up.
Forum: 5th Gen Camaro SS LS LT General Discussions 12-21-2011, 01:05 PM
Replies: 18
Views: 2,888
Posted By mattderk
I had a simular AC system failure in which they...

I had a simular AC system failure in which they had to replace the evaporator core. I asked them about the BCM reprogram but I dont think they did it.

I am having simular issues with AC not...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 06-06-2011, 06:17 PM
Replies: 4
Views: 558
Posted By mattderk
Any replies ? I am looking for the same.

Any replies ? I am looking for the same.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-23-2011, 12:02 PM
Replies: 26
Views: 3,953
Posted By mattderk
How did you make out with the subframe/tunnel and...

How did you make out with the subframe/tunnel and spacing ? I have the 3" borla atak exhaust (w/ kooks headers and high flow cats). I have the rubbing issue on the stock tunnel brace and am curious...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-09-2011, 08:51 AM
Replies: 129
Views: 26,558
Posted By mattderk
I went to the shop that did my heads and cam. ...

I went to the shop that did my heads and cam. They found the damaged o-ring and check valve after removing the pump. I wasnt having GM do it since this is $$ out of my pocket.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-05-2011, 02:34 PM
Replies: 143
Views: 20,278
Posted By mattderk
In the end the issue was a jammed check valve and...

In the end the issue was a jammed check valve and the o-ring was cut. GM installed the oil pump with a cut o-ring .. nice quality control. There is the source/start of my issues.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-05-2011, 02:24 PM
Replies: 129
Views: 26,558
Posted By mattderk
Yes 20/20 hindsight. In the end the issue was a...

Yes 20/20 hindsight. In the end the issue was a jammed check valve and the o-ring was cut. GM installed the oil pump with a cut o-ring .. nice quality control. There is the source of my issues.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-04-2011, 12:16 PM
Replies: 143
Views: 20,278
Posted By mattderk
I called GM corporate and talked to another GM...

I called GM corporate and talked to another GM dealer .. both denying me any help, except a bill or the door. I'm having it done by another place and putting in a highperformance pump so it doesnt...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-03-2011, 03:32 PM
Replies: 129
Views: 26,558
Posted By mattderk
Dealer wouldnt cover for me .. trying to force...

Dealer wouldnt cover for me .. trying to force them by calling gm direct.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-03-2011, 03:30 PM
Replies: 129
Views: 26,558
Posted By mattderk
I have this issue and dealer refused service due...

I have this issue and dealer refused service due to my cam and pcm tune. Anyone have any issues / luck with dealership ?
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-03-2011, 03:22 PM
Replies: 143
Views: 20,278
Posted By mattderk
Did you have any mods ? I have the same issue and...

Did you have any mods ? I have the same issue and dealer is denying to cover due to camshaft and pcm tune.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-19-2011, 07:44 PM
Replies: 2
Views: 607
Posted By mattderk
How did you make out with this ? I am having...

How did you make out with this ? I am having this issue, I plan on calling technostalgia later this week.
Showing results 1 to 19 of 19

 
Forum Jump

All times are GMT -5. The time now is 09:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.