Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
RDP Motorsport
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums

Showing results 1 to 30 of 371
Search took 0.06 seconds.
Search: Posts Made By: POS Dakota
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 06:58 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
I've read about these as well. Belt does look to...

I've read about these as well. Belt does look to be pristine.
Guess you're supposed to tension it to 200 lbs (however you do that), then re-tension it to 180 after a run-in. I hope it's something...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 06:21 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
You're right BTW...I did some reading and these...

You're right BTW...I did some reading and these newer setups are something else.
I can disconnect the current sensor and check the voltage then to confirm. It should put out full voltage is what I...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 06:02 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
If I turned on a bunch of stuff like the...

If I turned on a bunch of stuff like the headlights and ac, I should have seen something happen, but I didn't.:iono:

I'm just going to take it in and let the dealership figure it out.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 02:33 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
I thought it was going to end up being something...

I thought it was going to end up being something a lot worse.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 01:58 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
It's definitely not slipping. tensioner is good....

It's definitely not slipping. tensioner is good. Like I said ealier, I should never see 12.6 volts on the display with the car running. 12.6 volts is the output of a healthy battery alone. If I rev...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 01:41 PM
Replies: 21
Views: 1,129
Posted By POS Dakota
Alright, I think it's the alternator. I took my...

Alright, I think it's the alternator.
I took my wife to the airport and for a while during my trip I was reading between 12.5 and 12.6 volts. Then suddenly it started to climb to the usual 14.2 or...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2013, 11:31 AM
Replies: 21
Views: 1,129
Posted By POS Dakota
Nobody?

Nobody?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-14-2013, 12:57 PM
Replies: 148
Views: 12,238
Posted By POS Dakota
BEEFY.:w00t:

BEEFY.:w00t:
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-14-2013, 08:21 AM
Replies: 21
Views: 1,129
Posted By POS Dakota
I would be pretty proud if it was. ;)

I would be pretty proud if it was. ;)
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-14-2013, 07:52 AM
Replies: 21
Views: 1,129
Posted By POS Dakota
Squealing noise under hard accel

Hey guys, been a little while.

For the past couple days or so, I've had a squealing noise. Not sure whether it's the throwout bearing or belts. It's a high pitched screech noise.

I don't see...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-09-2013, 12:58 PM
Replies: 58
Views: 3,028
Posted By POS Dakota
When I installed my kooks and high flows, I would...

When I installed my kooks and high flows, I would get a CEL every maybe 200 miles. But it stopped happening. I dont get it anymore.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-09-2013, 12:45 PM
Replies: 17
Views: 1,356
Posted By POS Dakota
They fit good, but you may want to check the hose...

They fit good, but you may want to check the hose nipples on them. My passenger side cover somehow loosened up and let go which caused a massive unmetered air leak. For some reason i was getting...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-09-2013, 12:42 PM
Replies: 34
Views: 1,928
Posted By POS Dakota
It annoys the shit out of me with the fuse pulled.

It annoys the shit out of me with the fuse pulled.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-21-2013, 05:08 PM
Replies: 308
Views: 28,897
Posted By POS Dakota
I shaved my balls for this?

I shaved my balls for this?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-19-2013, 11:21 AM
Replies: 27
Views: 1,121
Posted By POS Dakota
Livernois wouldnt do anything irresponsible like...

Livernois wouldnt do anything irresponsible like that.
I'm tuned by them as well. I've never had any reason to try and pull the fuse.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-14-2013, 04:47 AM
Replies: 66
Views: 3,986
Posted By POS Dakota
Nice to see they finally did them. Sounds good.

Nice to see they finally did them. Sounds good.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 08:56 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
Yep, but they are really marginal. Either way...

Yep, but they are really marginal. Either way they do the job for the car in factory form.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 08:31 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
light is good. And valvetrain failure is...

light is good.

And valvetrain failure is almost always the springs, or the lifter that was mismatched with the spring.

I prefer beehive springs in my engines. They've worked out very well for...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 08:09 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
hehe right they are, but for how long? If you...

hehe right they are, but for how long?
If you dont mind fixing one, nuff said.

If you're a kid on a limited budget and can't, probably shouldnt go there.

The engines I build for my amusement...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 06:12 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
7500 is high for any ls3 stock bottom end. ...

7500 is high for any ls3 stock bottom end.

They call it "grenading" because it usually starts by pulling out the pin.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 06:02 PM
Replies: 215
Views: 8,449
Posted By POS Dakota
Oh that sucks SO BAD!!!! You may hate me...

Oh that sucks SO BAD!!!!

You may hate me for saying this, but you now have metal all over the engine and likely lodged into the piston skirts. You might want to explore the possibility of taking...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 12:53 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
You can put out HUGE power with not a whole lot...

You can put out HUGE power with not a whole lot of inches. The combo just has to match, and of course the low rpm performance is going to suck unless you have the gearing etc to go along with it.
...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 12:32 PM
Replies: 27
Views: 1,648
Posted By POS Dakota
I've read here and there about people bitching...

I've read here and there about people bitching because they ordered them a while ago and they pushed out the ship date.

But they have a history of making some good stuff.

I'd personally...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 12:31 PM
Replies: 32
Views: 1,228
Posted By POS Dakota
Any longevity issues on the titanium valves? Do...

Any longevity issues on the titanium valves? Do they use some kind of copper/beryllium seat to alleviate it? I've always used ferrea stainless valves.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 11:36 AM
Replies: 80
Views: 4,956
Posted By POS Dakota
12.4 is good given the situation. I'd be happy...

12.4 is good given the situation. I'd be happy with that so far.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 11:34 AM
Replies: 49
Views: 3,069
Posted By POS Dakota
Solid! Install it, set the gear lash with a piece...

Solid! Install it, set the gear lash with a piece of newspaper, and beat the piss out of it without ever worrying.:thumb:

I had one milodon geardrive last through 3 brutal engines until I decided...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 10:36 AM
Replies: 11
Views: 766
Posted By POS Dakota
It's a good thing too because IAC solenoids and...

It's a good thing too because IAC solenoids and valves are just another maintenance item. They eventually get crap in them and the car will begin to idle rough and/or stall when the duty cycle can no...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 10:05 AM
Replies: 49
Views: 3,069
Posted By POS Dakota
What turns me off about the v6 is the 1.5 miles...

What turns me off about the v6 is the 1.5 miles of timing crap in them.
I won't dispute that DOHC flow really well or that the v6 is a decent engine for what it is, but on the track it's all up in...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 09:53 AM
Replies: 27
Views: 1,648
Posted By POS Dakota
Yeah...what's the deal with those guys? I...

Yeah...what's the deal with those guys? I remember it takign forever for them to release their heads. Are they able to be purchased now?
The last I remember is there were delays for whatever reason....
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-27-2013, 09:52 AM
Replies: 27
Views: 1,648
Posted By POS Dakota
I know a guy with an ls3 who kissed the 700hp...

I know a guy with an ls3 who kissed the 700hp mark with Mast Heads.
N/A Bitches!!!! lol
Showing results 1 to 30 of 371

 
Forum Jump

All times are GMT -5. The time now is 11:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.