View Single Post
Old 10-23-2009, 06:06 PM   #1
MGW
 
Drives: 2010 CAMARO SS
Join Date: Aug 2009
Location: AUGUSTA, GA
Posts: 235
ATTENTION ANY MGW SHIFTER GUYS THAT HAVE THE SHIFTER INSTALL CORRECTION>>> READ ASAP

OK GUYS I MADE A BIGGGGGGG GOOOFFFFBALLL MISTAKE ON THE LAST STEPS OF THE INSTALL VIDEOS!!!!


WHEN YOU TIGHTEN THE 2 HEX BOLTS HOLDING THE SUPPORT ARMS TO THE SHIFTER BODY YOU WANT TO MAKE SURE THEY ARE NOT FULLY TIGHT UNTIL YOU RAISE THE TRANNY BACK UP.


IF YOU DONT YOU WILL HAVE THE SHIFTER NOT LEVEL WITH THE SUPPORT PINS.

YOU WANT TO LOCK DOWN THE BACK BRACKET WITH THE BLUE BUSHINGS THAT THE PINS GO INTO AFTER YOU PUT THE BOOT IN OF COURSE . THEN PUT THE TRANNY SUPPORT MOUNT BACK ON THE CAR AND THENNNNNNN FULLY TIGHTEN THE 2 HEX BOLTS ON THE SUPPORT ARMS AFTER YOU MAKE SURE THE SHIFTER IS LEVEL!!!

SORRY FOR THE GOOF

GEORGE
MGW is offline   Reply With Quote