|
LT4 Supercharger bleeder tool!
I was having higher than expected temps on my IAT 3 and Ted at JRE recommended this tool. It's probably the best $89 I've spend on a tool!
It fits on a water bottle or a 2 liter bottle. To attach to the fill port/bleeder valve. Just pull the gold housing upward, then put the fitting on the fill port. It slips and snaps on the bleeder/fill port and locks in place when you let go and it's liquid tight. When your done, pull the housing back upward and pull the bottle off. All the excess liquid stays in the bottle and NO MESS! It was a breeze bleeding out the reaming air in my SC coolant system!
__________________
2023 ZL1 Auto - CSP 2" Long Tubes by Stainless Works | Gesi G-Sport High Flow CATs | Stainless Works Legend NPP Axle Back | Roto-Fab Big Gulp | Kong NM103mm | Kong X-Port | Griptech 2.3" Upper | ATI Super Damper w/18% 9.45" Lower | TooHigh PSI Port Injection w/875cc Injectors | Brisk RR14S Plugs | Granatelli Malevolent Coil Packs | Katech Low Profile Billet Valve Covers | Katech Duel Fuel Pump System | MightyMouse Wild 1000HP CC | DSX Flex Fuel Kit | DSX Billet Lid | DMS 2gal Fender Tank | NT555R2's 305/285 | Katech Tuned | Straight E85 = 784rwhp / 678 torque @ 19psi
|