#09-04-95-001A: Clicking Type Noise from Rear of Vehicle When Shifting Between Reverse and Drive or on Hard Acceleration (Add Washer to Wheel Drive Shaft) - (Feb 19, 2010)
Subject:Clicking Type Noise From Rear of Vehicle When Shifting Between Reverse and Drive or on Hard Acceleration (Add Washer to Wheel Drive Shaft)
Models:2010 Chevrolet Camaro
Built Prior to VIN Breakpoint A9194726 (V8 Engine) or A9194723 (V6 Engine)
This bulletin is being revised to provide VIN breakpoint information. Please discard Corporate Bulletin 09-04-95-001 (Section 04 -- Driveline/Axle).
<A href="http://gsi.xw.gm.com/si/showDoc.do?docSyskey=2404116&from=sm#ss1-2404116">
Condition
Some customers may comment on a clicking type noise coming from the rear of the vehicle when shifting between reverse and drive or on a hard acceleration.
<A href="http://gsi.xw.gm.com/si/showDoc.do?docSyskey=2404116&from=sm#ss2-2404116">
Correction
Add a washer between the rear wheel drive shaft and the bearing hub assembly using the procedure listed below.
- <LI type=1>Remove the rear wheel bearing and hub assembly. Refer to Rear Wheel Bearing and Hub Replacement in SI.
<LI type=1>Install the washer (1) onto the rear wheel drive shaft (2) as shown above. <LI type=1>Install the rear wheel bearing and hub assembly. DO NOT re-use the wheel drive shaft nut - replace with a NEW nut only. Tighten
Tighten the wheel drive shaft nut to 270N·m(199 lb ft).
- Repeat Steps 1 through 3 for the opposite side.
