View Single Post
Old 08-12-2010, 11:03 AM   #11
PfadtRacing
 
PfadtRacing's Avatar
 
Drives: 2010 Camaro, 2006 Z06
Join Date: Feb 2009
Location: SLC, UT
Posts: 3,377
Quote:
Originally Posted by GuidosCamaroSS View Post
anyone have a DIY for the pfadt endlinks? or any endlink?
Here is what is included with the Pfadt Endlink kit.
http://www.pfadtracing.com/blog/wp-c...ndlink-kit.pdf

Essentially, you just jack the car up, support it on jack stands.

Remove the old endlinks, which if I remember correctly need a 15mm ratcheting wrench, and a 7mm box wrench to hold the stud. The ratcheting part is key, other wise you have to use an open end wrench.

Then, in install our endlinks. Use a 1/2" wrench to hold the stud from turning.

That is pretty much it. The assembly instructions and where the parts go are in the document I linked you to. Any other questions let us know!
PfadtRacing is offline   Reply With Quote