View Single Post
Old 10-08-2010, 08:50 PM   #6

Drives: 2001 T/A, 2010 2SS/RS, 2006 Z06
Join Date: Apr 2009
Location: Lexington, KY
Posts: 2,435
I need to write the step by step installation instructions, with drawings tomorrow. I will include this in with each bowtie, and most likely send out as an email attachment as well.
The simple method is that:
1) Place the bowtie up to the hood insulation and make a mark on your hood liner where the bolt holes are.
2) Cut small slits, or "X's" at those locations.
3) Place the bolts through the bowtie, and the slits in the liner one at a time, and install the lock nuts, and washer we are providing you, on the back side.

It is important to note that the entire liner does not need to come off. This by only removing the four front plastic inserts on the liner. This will take about 10-15 minutes if you have all of the tools at hand. And in no way can these bolts touch your hood.

Thanks, Roger
SALE! Enter promo code:
WINTERSALE10 - 10% off orders under $100
WINTERSALE15 - 15% off orders over $100
Exclusions apply
dragonZ28 is offline   Reply With Quote