View Single Post
Old 02-02-2011, 05:00 PM   #3
AUS10BMX

 
AUS10BMX's Avatar
 
Drives: 2010 2LT RY, 2014 Silverado
Join Date: Nov 2009
Location: Greenville, NC
Posts: 1,248
So after looking around these threads for a while I started my lighting project.

First up I went with the fog lights:
6000K LED 5202 Fog Lights - iJDMTOY

I then changed the DRL/Turn Signals:
6000K V-LEDS TYPE 1
Alternating White/Amber Turn Signals - V-LED Type 1
W/ 50 W Resistor - V-LED 50w Resistor

Waiting For:
2010 Camaro ABL LED Kit
-(2) T10 5 LED 3 Chip "ABL" Colored Bulbs (Dome Light/Trunk)
-(2) 15" Long "ABL" Colored Footwell Strips

Camaro License Plate LEDs "White"

All from AAC Lighting

Future Plans:
HOD bulbs from AAC to closely match 6000K.

__________________________________________________ _______________

LED 6000K Fog Lights

These were very easy to instal and turned out great. Just turn your wheel as far as you can, and remove the 3 torque screws holding the wheel liner in place. Pull the liner back, remove the Fog Light harness, replace the new bulb, and turn it on!







DRL Turn Signal LED 6000K

With the Fog Lights installed, and having the DRL on, I could not stand the Amber colored bulbs always on! Completely killed the look. I decided to go with the V-LED switchback lights, and they turned out great! Just pull out your DRL lights, connect the 50w Resistor to the designated wires, plug in your new LED bulb. I disconnected the positive battery cable also.

For NON-RS Only (RS equipped requires different wiring to work properly, search)










__________________

Hypertech | Airaid | JBA Exhaust | RX Catch Can/CNC TB/Black Ice-Olator | Ported Intake/Heads | 1LE Brembos | F14's | RS Headlights | ZL1 Grille

Last edited by AUS10BMX; 03-31-2011 at 03:34 PM.
AUS10BMX is offline   Reply With Quote