View Single Post
Old 02-21-2011, 04:59 PM   #96
Beauwulf

 
Beauwulf's Avatar
 
Drives: '10 LT RS A6 & '04 Acura RSX Type S
Join Date: Oct 2009
Location: Florida
Posts: 1,529
Some more progress...

Inlet for the airbox is in the center. Notice the tabs for the "dams". I still need to fabricate a plate to "squash" the tubes (to make them oval) under the cross member. They will be even with the bottom of the frame with the plate.



Hoses run through the radiator deflector up to the airbox.







I ran into a bit of a problem getting the long splitter struts attached to the bumper. The honeycomb section is between the bumper beam and the fascia skin. I'll have to build a bracket to do that so, I re-enforced the old mount locations inside and out. Hopefully, along with the added support from the dams, it won't flex too much!



__________________
Beauwulf is offline   Reply With Quote