View Single Post
Old 08-03-2011, 04:35 PM   #313
pyr0b0y
need....more....hp
 
pyr0b0y's Avatar
 
Drives: The Neighbor Hater
Join Date: Dec 2010
Location: San Mateo, CA
Posts: 4,174
Went to the drag strip this past weekend with a couple other camaros. Best of the night was a 12.559 w/ 2.206 60' and a .125 RT. Not very impressive for a S/C camaro but i rolled into it rather than launched the car off the line. Felt a lot better not breaking an axel. It was 90* and didnt have wheel hop. My last run I had HORRIBLE wheel hop and fishtailed all the way into 3rd. I def want to go to the dragstrip again and learn how to lauch. Only improvement from a 12.559!

Last word on the new build: Engine shipped out last week and should be arriving at the shop sometime this week. Turbo kit should be shipping out this week. I'll be going with an Exedy clutch, not sure of the specs but Luke said it'll withstand the power I want!


Fnially decided on a finish for the rims. I need to take pics of my car and will get them done in photoshop if i have time. I will be going with a brushed finish with a chrome lip. The front rims will have a slight concave with a deep concave in the back. Similiar to this design:
Attached Images
 
__________________


Mast Motorsports Built LS3 Stroker 418, IPS GT35R Twin Turbos, Exedy GTO4XD Twin Disc Clutch, Aeromotive A1000 Eliminator Stealth Fuel Pump, AEM Meth Injection, DSS 1400hp Axels, BC Coilovers, Pfadt & BMR Suspension, Hawk HPS Pads, Drilled/Slotted Rotors, Hurst Shifter, Custom Roll Cage by Blu808, T3 Ports, 22" Custom Concave Mesh Rims
pyr0b0y is offline   Reply With Quote