View Single Post
Old 09-30-2011, 08:03 PM   #37
CFD



 
Drives: 2SS/RS L99 BLACK
Join Date: Apr 2010
Location: MASS.
Posts: 4,992
Worked on the mail slut a bit. I was hoping to have the scoop tacked up today but I ran out of Argon so no more welding until next week, bummer.

This is what I've gotten done, roughed out the mail slot, the oppening is much bigger than you would think, modified the radiator support, fabricated the upper deflector, this directs the airflow to the radiator, when finished it will direct air into the scoop that will go to the CIA along with my lower to scoops. I will be building my own CIA that will completely isolate air intake from anywhere near the engine or radiator, totally fresh air intake. The biggest step now will be programing the outer frame and grill, this will be key in making the openning blend cosmetically.

Here are a few photo's of where I'm at.
Attached Images
    
CFD is offline   Reply With Quote