View Single Post
Old 10-05-2011, 07:15 PM   #18
Kenji
 
Kenji's Avatar
 
Drives: 2SS/RS M6 SW
Join Date: Jan 2010
Location: No Cal
Posts: 273
Quote:
Originally Posted by Ject View Post
One thing i noticed after reading the instructions is it doesnt mention cycling the ABS... is this not needed? Id have to assume one would need to manually cycle the ABS system with a Tech II after an install like this.
All of installs and tests up to this point have not required cycling of the ABS system (ABS Automated Bleed Procedure). According to the service manual the only time this is required is when:
  • Base brake system bleeding does not achieve the desired pedal height or feel
  • Extreme loss of brake fluid has occurred
  • Air ingestion is suspected in the secondary circuits of the brake modulator assembly
None of these above conditions should occur if the installation instructions are properly followed and the brakes are bled properly before operating the vehicle.
__________________
Kenji is offline   Reply With Quote