View Single Post
Old 10-20-2011, 10:14 PM   #6
Mach

 
Mach's Avatar
 
Drives: White M6 1LT RS
Join Date: Mar 2010
Location: Canton, MI
Posts: 1,677
Quote:
Originally Posted by zkdreads View Post
what did you use to seal back up the lens to the housing. black=ground, yellow=positive
I used the stock socket. Just put it back in the housing. Removed the metal tabs off the stock bulb and wedged the bulb back into the socket with the led wires. Another words used the bulb to hold the wires against the contact points. I will eventually get a blank 192 socket and plug the wires into that socket.

Quote:
Originally Posted by showstopper View Post
Looks good can't wait to see the finished product.
Thanks!

Quote:
Originally Posted by sene View Post
If its the led strips are flexible couldn't you feed them through the hole in the back and not worry about splitting the lamp open?
They are flexible but not flexible enough to fit though the hole.. And there is that problem of lining it up properly and attaching it there. But if you built a ship inside a glass bottle before then you would have no problem. LOL
__________________
Pfadt Sway Bars - FE3 Suspension - Barton Shifter - IdealG's Clutch Master Cylinder - Trifecta - Vmax TB - Vararam Intake - MACE 25mm Insulator - Plenum Insulator - Ported/Gasket Matched Intake Manifold - Rx Catchcan - AAC DRL's - 4 Pack Aux Gauges - Steering Controls - AAC Afterburners - DIY Led Sidemarkers - ZL1 Front End

Next mod: Done!
Mach is offline   Reply With Quote