View Single Post
Old 11-17-2011, 01:02 AM   #90
Blue70SS

 
Blue70SS's Avatar
 
Drives: 2010 LS3Camaro2SSRS IOM in/out
Join Date: Aug 2009
Location: Denver
Posts: 2,024
Quote:
Originally Posted by jasycz28 View Post
How did you get the Welds to fit with the coil overs? Did you have to raise the car up in the rear?
Heated up the contact point on lower control arms with MAPP gas and pounded the #@!T out of them until it cleared, plus Coilovers as high as possible in the rear. Repainted control arm area with Black rustoleum. I tested it out with "tape tateltale" strips on 4 places of the wheel edge at Bandimere Speedway.... finally was able to launch sucessfully on M&H drag radial 325's with 15 PSI, Pfadt coilovers adjusted to zero on fronts, and 5 on the rears. Plus opened up the oval holes on the bottom of the control arms to make coilover adjustments easier and half moon grinds on top side of OEM gussets. I'll have to dig up some pictures and post up.
__________________
LPE 650+,IOM Pearl White Rallys
743 RWHP 681 TQ @91,TVS2300 10/14 OD 2.75/NW 102mm,RDS
NLP spoiler/GM splitter/Torq HE-fans/oil-tranny coolers/IC1000cc
boosted LPE Twin Pump,GT9,Coil Covers,Mats,Pedals/ADM Gauges,Race Scoop/Trunions
DDS CVs,Carbon F DS/RPM L6/LPE 9.5 3.73/Pedders HD bushes,align kit
RB 2-piece rotors,S/S Lines,Hawk HPE Pads/Forgeline SP3P/Weld RTS
Ceramic ARH 2" LT/3" X-pipe,Corsa Touring/BMR TA,Toe,LCA,DS Loop
StreetSlayer BC3/MTI Shifter-Trans mt/Hotchkis CB/Monster CC/SJM LineLock
PFADT Coil Overs,Sways,Links,Mounts,SF Bushes,Camber Kit

LPE Brotherhood
.
Blue70SS is offline   Reply With Quote