View Single Post
Old 01-11-2012, 06:48 PM   #11
Ray@RDS

 
Drives: 2010 2SS/RS
Join Date: Sep 2011
Location: Mn
Posts: 449
Quote:
Originally Posted by yotaman96 View Post
Wonder if it would be possible to weld the brackets to the bar and smooth it out to give the appearance of one piece?
The ends of the strut brace are cast aluminum, and the mounting points are machined flat. the new mounting pads would need a recess put into them, I just don't know how wide.., but due to the brace having a sloted side, I believe they made it to fit with variables in mind. that gap is very mine -ute. And it may be just my brace, due to the casting????
__________________
Super Street performance, In house Mustang AWD Chassis dyno, Manufacturer of the RDS Blower plates
check out superstreetperformance.net, or fb page super street performance, and or rayssuperstreetperformance on instagram... thx!
651-226-3109
Ray@RDS is offline   Reply With Quote