View Single Post
Old 01-16-2012, 12:08 PM   #118
Nathan Moreno
~ G5Carbon.com ~

 
Nathan Moreno's Avatar
 
Drives: G5.R
Join Date: Sep 2010
Location: SoCal
Posts: 2,265
OK, I'm replacing this piece with AN fittings an lines. But I had a couple of hours to burn and my dremel polishing kit..... so what the hell. Since I have no need for the piece, I figure we'd have some fun and I'm going to give it away for FREE to one lucky winner! I'm also throwing in a couple of ARP bolts to complete the look. The bolts by themselves are $5.99 each, not cheap.

Here are the rules; whoever posts closest to guessing my DOB without going over WINS! Will keep it open till Friday and than I will announce the winner.

Oh, I almost forgot... there's is a small shipping and handling fee of $129.99.

Just kidding, I pay for the shipping also.

Here's what I started with.



And here's work in progress.



I brushed the blocks and polished the tubes



In this picture, I still hadn't polish the inlet tube.



The pictures don't do it justice... whoever wins will see the difference when they compare both. Good Luck and less start guessing.
__________________
<img src=http://www.camaro5.com/forums/image.php?type=sigpic&userid=32176&dateline=1430409495 border=0 alt= />

Last edited by Nathan Moreno; 01-16-2012 at 04:03 PM.
Nathan Moreno is offline   Reply With Quote