View Single Post
Old 05-09-2012, 08:20 PM   #2
JusticePete
Rebel Leader
 
JusticePete's Avatar
 
Drives: Camaro Justice
Join Date: Jun 2007
Location: Texas
Posts: 15,600
Quote:
Originally Posted by camaro0220 View Post
Has anyone "miked" the rear subframe bushings and gotton all the dimensions from them? I havent crawled under mine or the wifes camaro and dropped the subframe yet to do it myself. I was thinking if someone had all the dimensions on a set of these bushings, since I have some t-6 aluminum stock and a lathe.......I could turn some down myself and try them out. Any ideas??
Yes, don't do it unless you are planning on this being a full time race car. The welds in the sub-frame are not designed to take the loads of solid sub-frame mounts. The sub-frame frame welds are prone to crack. We have seen this with the Grand Am Challenge cars. If you were able to speak with an engineer from the Camaro TEAM they would tell you the same thing.

What were you expecting in terms of a performance gain from your solid sub-frame mounts?
__________________
JusticePete is offline   Reply With Quote