View Single Post
Old 08-19-2012, 01:30 PM   #21
nak3dsnake


 
nak3dsnake's Avatar
 
Drives: 2010 Camaro IBM 2LT/RS M6
Join Date: Sep 2009
Location: Columbus, OH
Posts: 2,280
Quote:
Originally Posted by Sleepy View Post
ZL1 front spring rate IS identical to SS. They are both 27 N/mm. The rears are different, SS is 66 N/mm and ZL1 is 70 N/mm. Higher spring rate doesn't mean better control. Control comes from matching dampers to the springs in compression, rebound, and travel. What higher spring rate will give you is less body movement (body roll, brake dive, and squat under acceleration). You will think the same damper can be used for SS and ZL1 springs but it isn't optimal because the travel is different. ZL1 suspension travel is lower compare to SS but it can get away with it because MRC can dial in more compression when it detects a big hit. SS structs are not as smart. If you compare v6 to SS springs, you will see that lower 25 N/mm spring rate of v6 is compensated by longer travel of 96 mm. 25 N/mm x 96 mm = 2400 Newton unit of force to bottom out. SS springs are 27 N/mm x 84 mm = 2268 N.

I don't know about Mustangs so I am not going to comment on them but I will say something about aftermarket lowering springs. It is MY OPINION that most lower the car's handling capacity. Lowering springs have too little travel, too low of spring rate, and factory dampers cannot control them well. It is basically a cosmestics modification at the expense of handling. I am not saying you cannot lower your car with higher rate springs. All I am saying is that you gotta match those springs to proper dampers. Pedders supercar coilovers have 8kg/mm springs up front. This is twice the factory spring rate but it rides and handles very well. Compare that H&R super sport lowering springs that has very close to factory rates and you'll quickly see the importance of matching springs to dampers.
So the mag ride let's them get away with running the same rates in front and near the same in back with a shorter spring. I personally wouldn't lower my car but I had assumed that most manufacturers increased rates more than slightly over stock to compensate for the lower height.
__________________
Looks: AAC P13W DRLs, Heritage Grille, RS Embroidered Headrests, GM Door Sill Plates, GM Premium Floor Mats, Body Color Engine Cover, LLT Mobile 1 Oil Cap, ZL1 Sport Pedals, 3M Clear Bra.
Performance: Vararam Ram Air Intake, Hurst Short Throw Shifter w/ Hurst Hard Drive Pistol Grip, IDEALG Clutch Master Cylinder, RX Catch can, GTO clutch fluid reservoir, Brembo Brakes, 1LE Track Pack, GMPP Exhaust Upgrade.
nak3dsnake is offline   Reply With Quote