View Single Post
Old 08-20-2012, 09:13 PM   #735
pyr0b0y's Avatar
Drives: The Neighbor Hater
Join Date: Dec 2010
Location: San Mateo, CA
Posts: 4,090
Got the Ozmo carbon fiber intake installed over this past week. We ran into a couple issues, but nothing big. The intake tube needed to be modified a tad because the TB sticks out a little further than stock; nothing a little welding cant help! We also switched from the red aeromotive fuel rails to polished fuel rails for a cleaner look.

I was able to do a lot myself, taking off the intake, swapping injectors, and reconnecting the fuel rails and system up.

All I can say about the intake! looks freaking awesome in my engine bay!

Once I get some time, the heads will be coming off as well as the valley cover, so I can polish them to a shine to match the runners!

Here's a couple pictures of the install and what it looks like right now.

Removing the stock intake manifold

Modifiying the intake pipe

Finished product.....sorta!

From the last picture, a small part of the tube is hitting the hood. I will be taking off a little more of the intake tube on the bottom so hopefully it won't rub anymore. I will also be taking off the intake tube, removing the powercoating, and polishing it myself for a cleaner look.

Mast Motorsports Built LS3 Stroker 418, IPS GT35R Twin Turbos, Exedy GTO4XD Twin Disc Clutch, Aeromotive A1000 Eliminator Stealth Fuel Pump, AEM Meth Injection, DSS 1400hp Axels, BC Coilovers, Pfadt & BMR Suspension, Hawk HPS Pads, Drilled/Slotted Rotors, Hurst Shifter, Custom Roll Cage by Blu808, T3 Ports, 22" Custom Concave Mesh Rims
pyr0b0y is offline   Reply With Quote