View Single Post
Old 09-11-2012, 09:25 AM   #1
SSpade22's Avatar
Drives: 2010 Camaro SS (Twin Turno 418)
Join Date: May 2012
Location: Mooresville NC
Posts: 208
Arrow Pictures of my new build (in process) [COTW 2/4/13]

So right now my Camaro is in the shop getting a laundry list of modifications put on it. My shop has been kind enough to provide me with picture of the car and parts as they are being put on the car; I thought fellow Camaro lovers would appreciate it if I shared them with you!!!

I apologize some of the pictures are kind of big, if you zoom out a little it helps see them more clearly.
Car will be on the DYNO sometime this week, I will be sure to share the results with you.
Engine swap to a TSP 418 w/ 4in stroke with 10.5:1 compression
Kooks 2" Longtube Headers
Kooks Full Off Road Exhaust
West Coast Cylinder Heads
Pfadt Stage 3 Suspension Kit
Built RPM 4L80e
LS7 Lifters
LS2 Valley Cover
Lifter trays
LS2 Front Timing Cover
Deluxe Cam Install Package
ARP Head Stud Kit
LS9 Head Gasket
Custom Cam
9" Driveshaft Shop Rear End
Procharger F1R Setup
Yank 4L80e SC 3400
Yank Flexplate
FAST 102mm 146102
FAST 102mm gaskets
FAST 102mm billet fuel rail kit
FIC 2000cc injectors
FORE dual hat fuel set up
(Also took back seats out and a lot of useless stuff to make the car 300lbs lighter)

Attached Images
Engine Modifications:
TSP 418 w/ 4 in. Stroke Custom cam
Power-gilde transmision
LSA WCCH Ported Heads 1400hp Axle Shafts DSS
FORE Dual pump FIC 2000cc Injectors
Twin Garrett 53s

Last edited by SSpade22; 12-20-2012 at 10:20 AM.
SSpade22 is offline   Reply With Quote