My BMR Front Strut Brace Arrived Friday Afternoon, just in time for me to install it. I went over a friend's house to tackle the install in their garage. It wasn't too bad, pretty straight forward, you just have to make sure you get the suspension to free hang as far as possible to dislodge the strut assembly from the tower.
Clamped the Strut brace to mock up the holes for drilling :
Finished product :
I didn't notice a huge difference, I mainly purchased this piece for the look of the engine bay. I'm sure it tightens up the front end just a tad, but not enough to rave about it.