Originally Posted by CamaroSS45
Thanks for the post here .... and you know I am in the midst of a pretty large build as well. We are just working thru the tune and shortly to WOT Dyno runs. You, like many here, know their $hit so don't believe this to be a farce - and plan to ping Aeromotive tomorrow ..... But you know the players - industry - people..... What did they tell you and what route are you taking?
I am praying there was a bad batch of these but boy we have a small group with a common theme going here and if I had to time my purchase - it was likely at the same time yours was.
Appreciate the insight and some enlightenment would be nice from the manufacturer...... Again - they make a good product as we know and if this is a flop - shocked they are not addressing or jumping in here.
Like your install - we'd double covered all bases and don't even have an issue "yet" but much like a NW102 throttle body thread I am watching - I like to know where the storm may be before it hits.
Anyone with enlightenment - jump in - share
and also add ...
This is actually Matt, formerly of RX
... Mine worked fine for about 40 street miles and 10'ish or so track passes. Then the fuel pressure dropped on me at idle to nearly 20psi, I knew there was a problem at that point. I cranked up the regulator just to get it moved around the shop and then onto the dyno, at 737rwhp at 6100rpm's it came down to 20psi and we shut her down. I drove the car back from the shop to home, pump was terribly loud (Overheating is my bet) and killed on me at the CVS. It did restart a few hours later and is running now..
I got with Andy @ Squash and he sent over his double pumper return style system. We are going to swap the Aeromotive soon for the Squash and I'll be back out.
At this point I cannot tell you what failed, I do not care really what failed because I cannot take the chance of a failure on my combination (Or any motor), so I've decided to ditch it. I'll let you know if we see anything when we pull it apart, could be that short EFI fuel line ate through in the tank who knows. I just know with the Squash I'll be all se to go!
I owned a full fabrication shop up north for a bunch of years, all we used for external pumps were Aeromotive or Weldon. I can say I have had VERY minimal Aeromotive failures in the past, but that is on their external pumps. I guess the internal pumps just need to be addressed. So you know I purchased mine last year about this time, but the car never ran until this October with the new pump. So if there is a common bad batch maybe it is fixed?
BLACK FRIDAY DEALS IN FULL EFFECT, PM US!!!
We carry all the best products lines! Driveshaft Shop, Fore Innovations, American Racing Headers, Diablosport, East Coast Supercharging, Vortech Superchargers, Borla Exhaust, Magnaflow Exhaust, VMax Motorsports, Mantic Clutches, LG Motorsports