View Single Post
Old 01-19-2013, 04:27 PM   #4
MLL67RSSS

 
MLL67RSSS's Avatar
 
Drives: 67 Indy Pace Car
Join Date: May 2008
Location: Indianapolis
Posts: 1,144
The Pertronix is pretty easy to install. Just remove the points and mount it where they were. There is 2nd wire that, as stated above you have to hook to a 12V source and NOT the resistor wire already there. Also have to have the Pertronix low resistance coil for it to work properly. That was the first thing I did to my car when I got it. Woke it up a little too!

http://www.pertronix.com/prod/ig/ignitor3/default.aspx

http://www.pertronix.com/prod/ig/fla..._volt_ft3.aspx
MLL67RSSS is offline   Reply With Quote