Thread: Project G5.R
View Single Post
Old 04-05-2013, 06:14 PM   #39
The Stig
knows 2 facts about ducks
 
The Stig's Avatar
 
Drives: ...and they're both wrong
Join Date: Aug 2009
Location: The HMS Invincible
Posts: 26,680
Quote:
Originally Posted by Nathan Moreno View Post
Hey Doc, Have you sourced a supplier for the aluminum bolts and what bolts did you have in mind that we can replace?


Update:

Power Steering Rack


Here are the humble beginnings of what we started with.

Attachment 494029

the plan was to pay homage to the Pfadt suspension components.

In the picture below, we developed a game plan on how to style the rack. The red circles represented the parts that were to be polished for a chrome finish; the orange circle represented the part that we were going to anodize in the Pfadt orange; the beige circle, the body of the rack, we were going to try to come as close to the Pfadt struts color as possible. Like all good plans, things did change as we progressed.

Attachment 494030

The process started with the dissasembly of the rack. We enlisted Leeís Power Steering for the job.
Our first snag was that since this power steering rack was a new, late model design, there was not a tool available to remove the internal nut.

Attachment 494031

Most racks only require a four tooth socket to remove the nut. Ours required a five tooth socket. So we had to machine one.

Attachment 494032

Attachment 494033

Once the rack was completely disassembled, it was time to start detailing.
Not every day that you get to see the guts of your power steering rack!

Attachment 494034

We started to detail each separate component. This piece is where all the lines connect to. The plan was to anodize it orange to stay consistent with the Pfadt colors.
Raw beginnings: Since it was created by sand casting, it had a very rough finish.

Attachment 494035

In order to get a machined look, we hand sanded the entire piece. Hand sanding is a much more time consuming process than using power tools, but it is the most effective method to get an even surface.

Attachment 494036

Casted pieces will usually not give you as bright of an anodized finish as a billet piece. To help get that desired finish, we polished the piece to a mirror finish.

Attachment 494037

The piece was shipped to Pilkington Inc. in Utah to be anodized by the same company that does the anodizing for Pfadt.

Attachment 494038

The steering shaft and plug were also polished.

Attachment 494039

Attachment 494040

You can see where the nuts have been polished.

Attachment 494041

Next we prepared the tie rods for paint.

Attachment 494042

Before sending the housing to get powder coated in anthracite, we removed all of the seams and casting on the power steering housing. This is the before picture.

Attachment 494043

Many folks were instrumental in the completion of the rack. Jerry and Adam from Leeís Power Steering are hard at work putting the rack back together. These guys really know their stuff. They machine pretty much all of their own stuff. The cad plated fittings were machined at the shop.

Attachment 494044

In order to replace the factory hard lines with AN stainless steel braided lines, Leeís Power Steering machined these fittings. We had them CAD plated to provide a nice contrast.

Attachment 494045

Next up was the installation of the braided lines.

Attachment 494046

Attachment 494047

Attachment 494048

There wasnít a detail that didnít get addressed. The factory clamp below is of the garden variety and not up to the level we desired. So we replaced them with stainless steel clamps which were polished before they were installed.

Attachment 494049

Attachment 494050

Attachment 494051
Soooo pretty.
__________________
Click to view my build thread
The Stig is offline   Reply With Quote