Thread: LS3+ cam =.....
View Single Post
Old 04-21-2008, 07:00 PM   #24
swazworth
the nerd king
 
swazworth's Avatar
 
Drives: 2005 scion xb...
Join Date: Jul 2007
Location: phoenix, az
Posts: 428
Quote:
Originally Posted by Grape Ape View Post
Itís not difficult, itís just a lot of work. You have to remove the water pump, timing chain, intake manifold, valve covers, rockers, a mess of hoses and wire. You also have to either remove the radiator and (some or all of) the grill/front clip or pull the engine out. The only really tricky part is getting the cam timing right and not leaving any leaks.

You shouldnít have to buy any tools, and if you do they are tools you should own anyway (except the engine hoist which you can rent). An experieced freind and/or shop manual will make things a lot easier.

You may also need new, more compressible valve springs if the new cam adds enough lift to make the stock springs stack or bind. If so then you will need a valve spring compressor and length of rope to stuff into the chamber (though the spark plug hole) to keep the valve from falling in. Iíve seen kits that allow you to use compressed air to hold the valves up, but if you lose pressure, you may end up having to pull the head to get the valve out.
ok then, i say we just let gm save us all this work and let us order one from the factory with this cam.



who is with me???
swazworth is offline   Reply With Quote