View Single Post
Old 05-09-2013, 11:55 AM   #636
JusticePete
 
JusticePete's Avatar
 
Drives: Camaro Justice
Join Date: Jun 2007
Location: Texas
Posts: 15,143
Quote:
Originally Posted by DuskSS View Post
ive got this issue ;(
major thunking on passenger side when going over small speed bumps.
Quote:
Originally Posted by Mohamed Sharaf View Post
I have the same issue with my 2012 2LT/RS and it is still exist!!

Camaro Front End Noise Correction


Inspection -- Determine if the upper spring insulator is black rubber or beige urethane.

Inspection -- If it is black rubber and partially displaced, replace it with the updated steel and urethane insulator.

Inspection -- Is there any damage to any of the front end components.

Inspection -- If available test drive with chassis ears in place to identify the source. If chassis ears are not available complete the 9 Steps listed here.

1. With the weight of the car on the wheels, remove the strut retaining nut and plate.
2. Burp the exposed strut assembly nut tight with the biggest baddest air gun in the shop. TQ is the key. We need a sudden acceleration of the nut to make it tight.
3. Reinstall the strut retaining plate and strut retaining nut. Tighten with the same over kill air gun for the same reasons.
4. Hit the strut clevis bolts with the same gun.
5. Hit the endlink nuts with the same monster gun. Don't do it by hand. Crank them down.
6. Get a wrench and all three ball joint nuts. Make them mechanic tight.
7. Crank down the radius arm nut and bolt to the same standard. Mechanic tight.
8. Get a socket on the sway bar strap nuts and make them mechanic tight.
9. Hit all four steering rack bolts and make them mechanic tight.

The 5th Gen Camaro is a ZETA II front end. We have seen issues with the G8 in the USA and the Commodore in AU. Chevrolet addressed those issues with large more robust ball joints and studs. Pontiac has addressed them with a TSB to replace the LCA and radius arms. There is NO issue with those components on the Camaro. Replacing the arms on G8s does not eliminate the noise because there were additional sources. Those sources are what appear to be tight to spec nuts on ball joints, endlinks, steering rack mounts, clevis bolts and strut mounting hardware. (The Camaro strut mount is different from the G8, but similar in that it has two nuts one below and one above the strut mount). Tightening the bolts is the key to resolving front end noises. What makes it tough for the DYI is lack of access to a high volume high pressure air supply to power a rattle gun.
__________________
JusticePete is offline   Reply With Quote