Quote:
Originally Posted by Monchy36
The introduction on the BF bottle said: use only a dime size amount of sealant for every 2x2 area, when I put that amount on the pad and start doing my 1st pass, I didn't see the sealant on the paint, that's why I applied by hand...
|
The way I do it is kind of make a ring or spiral on the pad. Then I tap the pad around on the paint to spread it around. Then turn on the machine and actually apply it.
I use a lot more than a dime size, bit I also work a much larger section than 2x2. On a Camaro my sections are:
Divide the hood in half. 2 sections
Front fender panel (smaller, less sealant)
Each door is one section and hit the mirrors
Divide roof in half and hit the pillars
Each rear quarter
Trunk lid
Rear fascia
Front fascia
Does that make sense? I'm doing a truck tomorrow I can take some pics if its not too late.
Sent from my Galaxy Nexus using Tapatalk 2