View Single Post
Old 06-26-2013, 07:10 PM   #4
Mchlgrrsn
Stroked and blown
 
Mchlgrrsn's Avatar
 
Drives: 2010 LS3 2SS
Join Date: Dec 2012
Location: Bridgewater, NJ
Posts: 1,461
Quote:
Originally Posted by 11syn3rgy View Post
I appreciate that. That's what is interesting. Ted recommended that I install 80lb injectors? Doesn't that seem like overkill for my set up? Any idea what the 3.6 pully will increase my boost to? I believe the stock pully is around 6-7 psi? Seems like I could do a little more boost than that without getting too crazy. At what level should I think about the BAP? I really don't know anything about them and I want to make sure that I'm not hurting my car. Especially since I'm kissing my warranty buh bye.

It's a good idea to follow the advice of your tuner/builder. If your going to raise the boost, make sure your fuel system is in order. Better safe than sorry. IMHO
__________________
LME 416 LS3 shortblock/Callies Compstar 4340 4"crank/Callies 6.125 H beams rods/Wiesco 4.07 forged pistons/Cam Motion custom LS1/LME ported heads /maggie TVS2300/I West 8rib 10%OD /3.2 pulley/OD cog drive/JRE tensioner/ID850 /ADM dual fuel/Kooks LT 1 7/8/magna flow2.5 /cat delete/Roto Fab CAI /MGW short throw /SPEC super twin clutch/G Force built trans,carbon syncro rear shaft upgrade /DSS 9"single CF DS /Strange 3.70/31 spline trutrac/MT DR's/earls oil cooler /tuned KHC
Mchlgrrsn is offline   Reply With Quote