Has anyone else noticed rubbing between the body and lowering mechanism? If I look in the opening toward the front of the car. I can see where the paint has been scraped away and transferred to the scissor assembly. It is the same on both sides. The assembly is not close though when the top is lowered.
Trying to see if this is normal or not, my gut says it is not. I'll try to post some photos later on to show it.
Added photos below
2012 1SS/RS Vert. BBK shorties, Solo cats, GHL catback, PFADT sways, tie rods, trailing arms, lowering springs, rear subframe bushings.
Last edited by Top Off; 07-08-2013 at 09:20 PM.
Reason: Added photos