View Single Post
Old 08-16-2013, 02:06 PM   #13
Account Suspended
Drives: SS/RS
Join Date: May 2010
Location: Transplanted from NYC..(ret. NYPD).Now in CT
Posts: 904
Send a message via AIM to epstein
Just my opinion.... But I wouldnt go smaller than 3.25 on stock bottom end

You can see from my sig I did all the fuel upgrades before I went to a smaller pulley...

during the dyno run as was stated...9.5 psi....and when the rpms approached the limiter...was just shy of 12 psi.....

My next step is forged internals on stock displacement. Along with a JRE Cam Package and a 3" pulley.
epstein is offline   Reply With Quote