View Single Post
Old 10-02-2013, 10:10 PM   #21
camarosspower
 
camarosspower's Avatar
 
Drives: 2010 camaro ss
Join Date: Jun 2010
Location: Port Arthur, Tx
Posts: 249
I finished my rear springs today . I'm wondering if everybody else unbolted the trailing arms toe rods upper control arms etc . The way that I finished my installation was by leaving both bolts (the one that holds the struts and the one from the lower control arm) loose and then tighten them up once the car was in the ground. Did I do this right or did I mess up big time? I plan on getting the car aligned tomorrow.
camarosspower is offline   Reply With Quote