View Single Post
Old 10-03-2013, 02:14 PM   #9
blazzin1


 
blazzin1's Avatar
 
Drives: 2010 2SS/RS R6P
Join Date: Nov 2008
Location: Seffner, FL
Posts: 4,266
Quote:
Originally Posted by gelboy1015 View Post
So instead of replacing the stock bushings with the BK017 bushings and using the stock bracket, these will just replace the whole thing?

Might just have to sell my BNIB bushings lol.
Yep, that's how it works! I would highly suggest going this route, as getting the OEM bushing out of the stock brackets can be a royal pain in the @$$!!!! Also, just FYI.....this can be done without removing or even lowering the rear subframe. It's a little tight, but it can be done, I did it. Just don't count on getting a torque wrench up in there!!! I used some blue Loctite and good ol' "German Torque" (a.k.a. good-n-tight).
blazzin1 is online now   Reply With Quote