View Single Post
Old 10-04-2013, 01:26 PM   #10
Da Mammer
Drives: 2010 camaro SS LSXFoFiddyFo
Join Date: Nov 2012
Location: Pennsyltucky
Posts: 225
Awesome piece. Craftsmanship and quality are over the top. Also very necessary for those looking to minimize weight.
I see a VIN so that can't be a COPO but sweet baby Jesus somebody is building one the right way from the ground up. Thanks for the input. I'd like to cut down the weight of my porky pig especially since I added a cast iron block to the mix, but I know $1800 could go towards something much better weight saving wise than 30 dead pounds but I figured since I'm pulling the motor this winter I may as well since I'm there. But I didn't want to blindly spend almost 2k for something that may seem...unnecessary.

Also for those that said BMR I called them and was told that R&D is still designing one. Not even to test phase yet.
Da Mammer is offline   Reply With Quote