Thread: Brake ducts
View Single Post
Old 12-12-2013, 05:44 PM   #91

Avalnch's Avatar
Drives: Rally Yellow Camaro+Avalanche
Join Date: Dec 2009
Location: Vancouver
Posts: 903
Modifying the Apex air scoop

Received my Quantum brake duct kit from JDP (no instructions btw).

Kit looks fine, but now I'm thinking about how to make it work with my Apex air scoop. The spot where the scoop sits already takes up 100% of the real estate that the brake duct would need. Plus, there is no more room anywhere else. So, my idea is to modify the air scoop as follows:
Name:  ApexScoop_duct_mod.jpg
Views: 431
Size:  37.0 KB

The air will get channeled into the duct via the scoop. Should be an easy mod to do. What do you guys think?

Come to think of it, might not even need the duct connection pipe. Just have the 3" flexible duct extend a bit into the scoop and secure it so that it doesn't fall out.
C.A.I., ARH LT, Pypes Cat Back, ZL1 Shifter, Quantum Brake Ducts, JDP Tow Hook
Scorch Yellow Trim Kit, Shark Fin, AAC DRLs+ABLs+SMDs, ZTA Rear Spoiler, R.Y. 1LE Splitter
Pfadt coilovers, camber plates, trailing arms & differential bushings.
BMR adjustable toe-rods. Pedders ZL1 barz, rear cradle inserts, radius arm & steering rack bushings.
Hotchkis Max Chassis Brace (minus tunnel cross-over piece for SCCA rules)
1LE 3.91 gearzzz. Drive Shaft Shop Road Race Axle Upgrade. TurnOne power steering pump.
Forgeline GA3-R 19x11 + Hoosier R6 315/30R19
426 HP @ 5550 RPM / 427 TQ @ 4700 RPM
Avalnch is offline   Reply With Quote