View Single Post
Old 02-23-2014, 10:17 AM   #5
EarlyApex
 
Drives: 2013 IOM 2SS 1LE
Join Date: Aug 2013
Location: Damascus Or
Posts: 261
I have it on my hoist at eye level. So far I've tried the propane torch and BFH on both the side of the spindle and end of the ball joint and just succeeded in mushrooming the end of the stud. If the arms are really that cheap the pickle fork might be the next step.

I got my 1" lowering springs installed and would have finished the rear sway bar except one of the bushings they sent is for a 1 3/8" bar instead of 1 1/8" so can't finish that until I get the right part.
__________________
EarlyApex is offline   Reply With Quote