View Single Post
Old 05-10-2014, 12:13 PM   #2
Dimitrim
Dimitri
 
Drives: 68 GTO 455 Ram Air; 2013 Camaro 2SS
Join Date: Jan 2014
Location: Novato, California
Posts: 231
It's been a couple of months since I did mine...As I recall, those bolts are in there correctly. If you go to the BMR website it has instructions on how to get the bolts out. What I did was to put my floor jack under the diff and support the weight. There are 4 large 15/16 bolts that hold the diff assembly on the bottom going up. With a large breaker bar remove one bolt at a time and then put the bolt back in at least 1.5". Do this on all 4 bolts. Slowly lower floor jack and you will be able to remove the toe arms bolts. After you are done replacing the toe arms, raise floor jack and tighten the 15/16 bolts to 130 ft/lbs.
Dimitrim is offline   Reply With Quote