Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

mws444 · 12-13-2011, 08:27 PM

Now we're talking! Got all of the race deck but the cuts around the lift in and down. Was too excited about the cabinets to take the time to get them cut on Sunday.

Also got if the Moduline cabinets, they are all installed now but I only have a pic of the short wall. I will try to get a couple of pics of all of them once we get the floor cleaned up. Man I am drooling about shopping for enough tools to fill these puppies up.

12-13-2011, 08:27 PM	#276
mws444 Drives: 701 RWHP Lingenfelter/Pedders Beast Join Date: Apr 2009 Location: El Paso Posts: 2,973	Now we're talking! Got all of the race deck but the cuts around the lift in and down. Was too excited about the cabinets to take the time to get them cut on Sunday. Also got if the Moduline cabinets, they are all installed now but I only have a pic of the short wall. I will try to get a couple of pics of all of them once we get the floor cleaned up. Man I am drooling about shopping for enough tools to fill these puppies up. Attached Images __________________ Lingenfelter forged balanced and blueprinted LS3, Maggie TVS 2300 LPE 9.5" Rearend 3.73,LPE dual disk clutch,10/14 rib belt drive, MTI shifter,RPM Level VI,Corsa stainless cat back, Racing Brake Rotors, LPE calipers, LPE twin fuel pumps, American Racing long tube headers, GT9 cam Port and polished heads and an ADM majic tune. 701 RWHP,Fully Pedderized w/complete bushings and Sportsryder Supercar Remote resevior coilovers. CCW 505t's Nitto Invo's and DR's Beware of the LPE Brotherhood!