edit I have 10mm end links
when I put my front BK016 bar in I didnt have to drill anything had 18mm nuts on the end links and I got the stock bar out on jack stands pretty easily without lifting the motor. getting the new bar in took a while. Had to bend the ps line a little by hand and then I got the bar caught on the pass side rear stud for the sway bar bushing. After a while i got pissed and just smacked the bar with a rubber mallet from under it on the pass side. It popped off the stud and fell in.
__________________
real ZL1 wheels and brakes, 285/305 Michelin Pilot Super Sports, Pray ported Intake manifold, Soler Throttle Body, Rotofab intake, EFI Tuning Flex fuel kit, full American Racing Headers Exhaust, 1 7/8" w/ cats H pipe and mufflers. Full 1LE suspension, with BMR adjustable sway bars and links, GM aluminum cradle bushings, Hurst shifter with lighter reverse spring, TWM shifter knob, Tick level 1 transmission. I should have bought a ZL1
Last edited by JCunningham; 04-01-2016 at 11:21 PM.
|