|
Step 1: Remove the 3 torx screws securing the wheel well liners to the front bumper on each side, this will allow access to backside of the bumper
Step 2: Remove the bumper plugs, by releasing the tabs and pulling out the backside of the bumper
Step 3: Install the foglamp thru the front of the bumper and ensure that the 3 mounts snap in tight
Step 4: Install the foglamp bezel from the front side of the bumper.
Step 5: Locate the wire harness on the passenger side of the bumper where the body harness plugs into the bumper harness.
Step 6: Disconnect this connector and put our connector inline, and reattach.
Step 7: Plug the foglamp wires into the lamps
Step 8: Connect the ringed terminal wire to the stud in the underhood fuseblock. See photo for stud location
Step 9: Switch installation: Run the single wire from the relay, into the car and find a suitable location to mount the switch. Connect the wire to the center terminal of the switch. Run the other 2 wires from the switch over to drivers side fuse block. Remove fuse #F17 (power outlet 1) from the fuse block and install it into the empty cavity on the add-a-fuse, then connect the add-a-fuse into F17. Install the ringed terminal wire to a good ground.
Step 10: Secure the relay up and out of the way with ziptie's
Step 11: Verify function: Should be able to turn lights on and off with switch when vehicle is running.
P.S. there on the site in the Installation Instructions tab.
|