|
with the harmonic balancer pulley, food for thought.
when you torque down that bold, your rear wheels WILL move, even with the e-brake on. I ran into this, we ended up taking the starter off and locking the fly wheel with a breaker bar in order to prevent this. the amount of torque your putting on that thing to tighten is ridiculous.
on a side note, you'll need to install the new pulley with the old HB bolt (as the new one is torque to yield) then remove it and install the new bolt. This was the only real difficult part of the entire process. Good luck!
__________________
Ordered: 1/15/2016
2000 status 02/01/16
3000 status 02/29/16
3400 status 03/07/16 TPW of 03/14/16
4200 status 03/17/16 in transit!
Delivered 03/23/16
2SS Hyper Blue | 6M | NPP | Mag ride | ceramic white Int. | Black out bow ties | P3 Gauge| Front splitter. | 6 pot upgraded brembo brakes. | Magnuson Supercharger/95MM pulley | Rotofab Intake | ZL1 side skirts | HRE FF04 wheels - Michelin PSS4 | ZL1 add ons rock guards and lift points. | AWE touring - resinated catback with link pipes.
|